Search results

I’ve been running the Predator cover for a few years. Nice quality and fit but not super rugged. It does not fit well over fording intakes, fording exhaust or tire carriers… Sent from my iPhone using Tapatalk

Front diff on the mill for thread repair. All new bearings going back in as well. Shout out to Carl Jantz on this for great work. Sent from my iPhone using Tapatalk

Differential is out. Gears look good. Ordered output bearings and seals. Housing LT bracket holes are in poor shape. Upper LT hole needs to be welded & tapped. LT lower hole has some pulled threads. Both will get inserts. Tighten and locktight those differential bolts! Sent from my iPhone...

More fun. Diff output leak cause is a fully pulled stub shaft. Looks like prior service pulled the whole shaft rather than removing the flange and could not figure out how to press the bearing in situ. Pulling the whole diff now to inspect and repair. Hopefully the gears and housing are still in...

Nice [emoji106] Sent from my iPhone using Tapatalk

+1 for RWH. Great community member who does top notch work. If you need a hand [emoji1672] locally for work you’re willing to take on yourself happy to help. Sent from my iPhone using Tapatalk

LMK where you found bearings…. Sheppard will not sell them to protect their rebuild business Sent from my iPhone using Tapatalk

My prior M998 went through a pitman and idler arm in less than 2 years with casual driving. I upgraded to A2 arms + center link with new TRE. Great steering after that. Sent from my iPhone using Tapatalk

Good progress this week. Sold my other project car and got the 1151 into the garage for service this fall. Covered tailgate chains with spare bicycle tube including required drain holes. Spot checked front camber 0.2-0.3 degrees. Sent from my iPhone using Tapatalk

[emoji28] Sent from my iPhone using Tapatalk

Bump, very interested in thickness/ballistic rating of these panels.

In Sent from my iPhone using Tapatalk

LF geared hub service and adjustment. Prior service had installed 1/4 steering arm bolts hand tight [emoji91]. More half assery [emoji90] Gears and bearings appear to be in good condition. Installed a new output seal and lock washer. Adjusted per TM and refilled. Also took the opportunity to...

Pic looks like a Saginaw box [emoji403] on this one? Sent from my iPhone using Tapatalk

https://powersteeringseals.com/product/sheppard-m83-heavy-duty/ Ordered this kit today. Sheppard also sells a seal kit through commercial truck suppliers. I spoke with the supplier today regarding coverage. This kit also covers the M83P2 gear. I spoke with Sheppard and understand they do not...

If you are sure you have an ECV/REV truck the Sheppard gears are available directly from AM General or the usual HMMWV suppliers. New expect to spend $1500-$2500 before tax and shipping. Sent from my iPhone using Tapatalk

Did you put urethane bushings in the end links? I found that one bushing is offset in the bore on stock end links. Replacement bushings do not account for this this binding on installation. The only way I found to make it work sub-optimally is to install the end links and bar ends first then...

Installed tire carrier lock bracket. Still need to source Jack handle and lock lanyard pin. Sent from my iPhone using Tapatalk

Curious if anyone has attempted a rebuild/reseal. The box on my 1151 has excessive sector shaft play and leaks. Figure it’s worth a seal and sector shaft bearing. Sent from my iPhone using Tapatalk

The plate is off atm. I plan on reinstalling when I get after the bodywork/paint Sent from my iPhone using Tapatalk