Search results

Hi My soft door windows have scratches and white spots and I wonder if anyone has suggestions on cleaning/polishing these. Thanks for the help. Ken

Hi Has anyone added a spotlight to their rearview mirror frame? Thanks Ken

Hi Can someone tell me what the torque for the oil drain plug? Thanks Ken:grin:

Hi I got my Humvee about 8 months ago and I knew the rear tires were getting down there and so I got 2 tires off of Ebay that were at about 85% tread. I have only had them on about 3,000 miles and the rear tires are less then 40%. Has anyone had this problem? Thanks Ken

Hi Need to replace the stock horn and wonder what some have come up with as a good horn to use. Ken

Hi Is there a molle cover that works on the low back drivers seat and the high back passengers seat? My Humvee is a 91. Thanks Ken

I have installed a Tach. and like many have had no luck getting it to work. I installed it per instructions on this sight and feel everything is wired right and with continuity at all points. I bought a new sender and still no luck. Has anyone ever determined what output should come from the...

Hi Could someone explain what (High L ) position does? Thanks Ken

Hi I installed a tach today and have a problem. This is the 3500 RPM tach with the terminal strip on the back. Anyway when I switch the ignition switch to run the tach will bounce up to about 1500 RPM and drop to zero right away and when I start the engine it sometimes will run up some RPM's and...

Hi I have a 1991 M998 and this has happened twice. This time I was installing a block heater. Got it in and started adding fluid. Got in about 10 quarts and the tanked topped up. So I installed the Rad. cap and after about 15 minutes of running the temp got up to about 160 and it started leaking...

Hi Looking to replace some of my flanged wheel nuts and all of my lug nuts. Half of my flanged nuts are rusty and half look like they are cad plated and cleaned up good. Need a good source for ones to replace the rusty ones. The lug nuts are rusty and I would like to replace them with the cad...

Hi Is there someplace that calls out the P/N's for the floor mats and tunnel mats? I have been trying to replace all of them from Ebay but got two that where suppose to be for the rear floor where your feet are but they where for under the seats. Also can anyone tell me what gets strapped in on...

Hi My question, is the 6.2 and 6.5 engine block the same. I plan on adding a block heater and have only found one called out for the 6.5. Thanks for the help. Ken

Hi First time here. Got a 1991 and wondering about the tunnel and how hot it gets. I would like to make a cover which would be plywood covered with indoor/outdoor carpeting on it and wrapped around the edges. Do you think this would be ok and should I place some sort of heat shield down first...

Hi I'm going to be adding a heater to the rig and wonder for those who have done this what type of heater did you use and what size (BTU'S) of heater. I live in an area that can get a little nippy being about 25 miles east of Yellowstone park in northern Wyoming.

Hi I'm not sure on this but I saw a picture of an M37 that appeared to have a modified jerry can mounted on the right rear side of the bed. It looked like the can had been shorted in height. Has anyone seen anything like this? Again the picture was small and taken from an angle up front of the...

Good day I want to add an AM/FM either tape or CD to my M37 under dash. Any one have any good suggestions as to brands or what ever? Thanks for the help Ken