Search results

RE: Posting M151-A2 for my Father-In-Law He wants to sell/tr www.sarafan.com call Michael in Miami and see if he is interested in trading for a M35A2.

Don't grind her too much (the M1009), or you will be in need of a new flexplate.

The water pure body with the erdlator set up is not an expansible van body.. It has a door right side and rear and the left side opens in the center half up and half down. It is extremely heavy with an uneven floor of steel deck plate and many holes for pipes and plumbing and the heaters take...

GM Group 3.107 part # 25004137 at your Chebby Dealer

See second post above.

So, I was wrong, by golly. (If I were a computer, I could blame it on shortage of 256K of RAM. ) But after consulting the "good book" I find the 1RED 2Z Thermo HZ from the end terminal on the 24V positive terminal board runs to the relay and becomes the 3 PPL6 (SXL) at the output side of the...

(Disregard this post and see the next one.)to run the relay? It is not the series hot wire to the starter. Just engages the 2nd relay on the starter drive. But I have been wrong before and will be again. Maybe I ran it to the back of the rear battery, but I am pretty sure it was to the...

Jump the purple wire in the bundle coming out of the firewall into the engine compt. to 24V (yup I changed it to 24V) and see if the starter turns, if so it is probably the relay. Take off some tape by the MC and you will find it. Scrape off a little insulation and run a jumper to the 24 (yup...

the GM # is 1105500 for the 100A 14V and 14067740 for the Leece Neville 28V 100A on the M1010

I use the green duckie now on the CUCV. Hi Jeffy, want some snow?

check with george at vtcsm37@aol.com he has taken a bunch of em apart. looks like GM 14072339.

Any Cummins dealer. Some civvy trux have the same filler cap, too.

RE: Re: RE: Electrical Problem Yes he is. I would expect that the low beam wire is mis- connected on one lamp with the low beam hot wire and you are getting feed back. Remember, too, that there is a cutout in the light switch which will cycle (circuit breaker) if you increase the amperage...

Try vtcsm37@aol.com George has scrapped a bunch of the trucks.

They would have been originally 24087, semi gloss. But were often painted by the user to suit their moods. I painted red pin stripes on mine in 1965, and got gigged at inspection.

Tank drains shut? Service and Emergency glad hand valves off? Tranny shift valve? Load the system with a remote source and listen for leaks, your engine need not be running for this.

I have new 3 lever switches for $50, ready to ship rampartsllc@aol.com

Assy is a bolt off job. Don't forget to disconnect the wiper hose. Heavy. Fold it down on a blanket on the hood.. The inner rubbers are a pain because of rust in the grooves.. Cut the old ones out and clean the grooves as much as you can. Start the new gaskets in the middle with...

Just use a 12V source like a battery charger and test em like any other light. Black to ground and red to power. Or a couple jumper wires off your wifie's VW battery.

sarafan.com in Florida