Search results

Thanks for your help. I will be installing it this week.

My mirror is loose and I was just wondering if it is serviceable. Is it a rubber grommet or is there a way to tighten it. ThX

What is the normal Temperature range of a healthy CUCV (with the heavy duty cooling system). I plan on putting a gauge in for this summer. I want to know when to get concearned (Im sure if the light goes on it too late). ThX

Im havent tried the carquest. I went into Kragen and the 18yo kids didnt even know what a hydroboost was.

I went down to Napa today and they said I was SOL and tried to sell me a rebuild for $214. My Hydraboost works good minus a very small leak inside the cab.

I sent him an email. Do you remember what you paid? I hape you can find it so you can share the part#. Thanks

I think I saw that too but couldnt find anything today. ThX

My hydroboost is leaking down the floorboard and I dont want to spend 200 on a rebuild. Where can I get a seal kit and what is the part #. I cant see it being that hard to replace the seals. The GM dealer here said it obsolete. I have searched napa and kragen online and I cant find it.

They are 36" swampers and I think I get around 12-15mpg.

I would but its all internal

Im still trying to get it off my hands. I have never had anything stick like this before.

I read this post and went straight out to buy some. I used 3 cans on the roof and front pillar. I think the roof needs another can in the center (might have to drill a hole). I am going to buy three more cans to fill the rear pillars, below the rear window, doors, and the open area below the...

For the M1010/M1028 Leece Upper napa PBH4019585 O.E.M. DAYCO Part Number Part Number 15599205 17585 Lower PBH4019520 O.E.M. DAYCO Part Number Part Number 15599206 17520 P steering NBH257455 O.E.M. DAYCO Part Number Part Number 14050459 15455 Ac O.E.M. DAYCO Part...

Does anyone have any parts # or knowledge/pictures of a radio setup that mounts above the glovebox or above the 4x4 shifter for the pickup. I want to install a radio but Im hung up on where to find the mount to place it in the cab. I have seen some M1009's with a radio in the front. I think...

I placed the equalizer on the fender between the front battery tray. I just had to move the battery closer to the motor. That way my 2ga. wires or super short. I ordered 140a breakers but I dont think I will use them.

Well I installed the equalizer. I did not delete anything and only installed the equalizer (just in case it ever fails so I have still two alternators and the DUVAC adding to the charge). It did the trick and keeps the front battery at 14.4v with the full 12v load. Easy/ cheap fix ($200)for...

I am looking for an artic kit for my m1008. Are there any issues because I have only seen them on 1009's. Where should I look to find one?

I running 36" swampers with a 4" rancho spring in the front and nothing in the rear. With front fender triming, the do great. For my M1028, there was no need to lift the rear to fit the tires(front does sit 2" or so inches higher) but no leaf wrap common with blocks.

After looking hi and low, I finally found the weakest part of a military vehicle (CUCVS and more). They were pricey at $30 (small price to pay when your thinking about blowing up your truck to generate some heat)but my friends and I never have to worry about being stuck somewhere without a...

Ambulancechser Thanks for the advice. I will remove the top and the DUVAC this weekend. Have you thought about plumbing your huge AC compressor for air?