Search results

There is a pin on the servo on the side of the engine. Use that to hold the speed control at max.

That’s right. Need to make sure all the coating on the boards is good and seal up any of the unsealed pots. running the engine for 15 or so min tend to get mine back online if I forget to keep it covered.

Sure, common problem. What I typically do is start the unit and let the heat from the engine dry it out. Its the inverter that is the problem. By controller are you referring to the inverter? There is a speed controller behind the instrument panel. That is not the source of this particular...

Everyone does. Its the single most handy thing I've ever bought.

When I got a powerplant setup the excavator wasn't able to lift it. I had to use it to just manage the unit and roll it off the side of the trailer. More than a little sketchy.

Yea, they loaded it with a grossly oversized wheel loader. When I'm ready to get it off the trailer I'll rig it to lift with the excavator and set it off on the ground. The two heaters will get forked off with the tractor. I'd use the tractor for the generator but it can't quite lift the...

Yep. Picked up another one. For some reason the ones on trailers sometimes go for better prices than ones not on trailers. Go figure. Ignore those other boxes. Nothing to see there. :D Anyway, I talked to the load out guy for a while today and asked about inventory. The lot is empty of military...

I have an A0 and from driving it around some with the new hubs I can say that the truck is not slower. I didn't take any measurements with the old hubs but I'll get out and capture some performance with the data acquisition system soon.

Yea, I took photos of the swtiches when I started. Verified that number on the chart and looked at the calculations in the manual and figured what it should have been. I did 712 and that was WAY off. Well, that didn't work. Ended up choosing a couple of values to see the scale of each change...

That was the dip switch setting.

Well, the math didn't work out like I expected. I settled on choosing a calibration and driving to see if I was over or under. I settled down on 440 as the number. At this point its splitting hairs with the GPS. Seems to be either a half a MPH under to half a MPH over depending on speed.

My calculations didn't work out perfectly. I'm going to get to the bottom of this and update the post accordingly. Mine was 356.

Your max load is actually around 105%. The green line is 100% under most conditions. One of the idiosyncrasies of these sets. You should be fine. They are tested to run in desert conditions.

For one the LPW4 engine on the 803 is ~1,800cc. The engine on the 003 is ~2,300cc. That itself isn't a predictor of power output but I can say the higher rotating mass of the larger engine will certainly help it handle surges better. I haven't done formal measurements but from looking at the...

MEP003 > MEP803. I own both. The MEP803 is a great unit and a beast in its own right but a good running MEP003 will run rings around a MEP803. ESPECIALLY in handling surge loads.

Its rated for 20HP on 3ph. Should work fine with a MEP803.

I hate to be the bearer of bad news but we don't have any technical info on the inverter itself. That is something a number of us here on the forum have wanted to find in an effort to facilitate repairs to the inverters but that has been an unfulfilled desire.

You will want to have the rotor tested for insulation integrity. At a minimum do a HIPOT test. I'll be surprised if it is OK.

I agree that the on forum search is lacking. The biggest issue is its minimum string length for searches. With all the short acronyms the militiary used for stuff it makes finding posts with MEP or ECO HUB challenging. Many times I have to resort to doing a google search limited to...

You can see how I solved the problem here - https://www.steelsoldiers.com/threads/cat-3116-engine-speed-sensor.203541/