Search results

Is this possible with the aluminum MRAP wheels?

Hello, Im wondering is there a way to completely delete the whole CTIS valve? reason I want to do this is because the whole piece is stripped inside 3 of the 6 valves I got, I find it more easier to just get rid of the whole valve if possible rather than fighting to get the broken piece out or...

It ended up being the thermostat gasket I put on was leaking. For the heating situation, I tested it with a thermometer and it seems like the gauge or sender unit is inaccurate, it was showing as 220 and kicking the fan on when the thermometer was at 160.

Okay Im back on this again, I have the aluminum wheels on the tires, which side does the adapter plate go on and is it different in the rear? (can't believe how much easier it is to remove aluminum wheels over the steel LMTV ones from the tires)

I know, old thread, but I'm finally getting around to getting these tires on, I just have to swap the wheels out. What RPMs do you have at 60Mph? Im going with the same MRAP rims and adapter plates but the goodyear tires

I post my shipping on both veritread and uship but always got a better quote on uship. You're shipping a whole vehicle?

I'm lucky to do 70 in mines with the 4 speed, although I have a big blocky top on the back that increases drag by quite a bit. I'm thinking about going with 40s next to increase the top speed a little. I already have a 2 inch suspension lift in the corner that's waiting to be installed

This is one heck of a unit! I wish waterloo was still building M35s and making kits for the truck, especially the overdrive but I came too late to the party.

It shouldn't be that hard to find someone that would ship a non running a humvee, try uship, I had a non-running BRDM shipped on there. Only part that was difficult is we needed a wrecker to get it off the trailer and into a storage unit.

If you get the measurements, please let me know, and what's your plans for the thick windows?

Does anyone have a picture of the jack in there? mines came with the cover but no jack or anything, I wouldn't mind getting a jack for that area.

Ok, so I managed to get a housing, got it yesterday, and installed it. After that, I took it out for a test drive for about 30 minutes, it still hits 220 quite fast and don't seem to be cooling any better at 195 degrees, my next plan is to change the radiator since I already have an aluminum...

I found one, its a bit more rare than I expected

Yep, I was going to do that until I realized I scraped the surface where the thermostat gasket would go at. And don't worry, disasters are addicted to me 😂

I'm going to disagree with some of the opinions here, I think a humvee would be a decent choice. I don't particularly have the ambulance top version, but I have the radio communication top and it does good enough on the highway with the 4-speed overdrive, "Typically I drive 60-65mph on the...

Well, that didn't work, I tried drilling it out but looks like its still stuck, I may just drill a hole and use a nut and bolt

How does the housing come off? I figured that if I removed both of the bolts from both sides, it'll pop off, but the side closer to the driver side don't want to come off If I had the housing off, I'll be able to get my torch on it better and have a better grip with some pliers on a vice

Yep, I checked that, there's no bolt in the back

Snapped it while removing it, I used the biggest pair of pliers I possibly could and couldn't get it to bulge any

I'll message you if everything else fails