Search results

Gimpyrob Thank I will run these for now . I like the look of the glass lens and these I can see if they are working in the day time.

Blackout lights on 1954 m269 where looking rough I made a brass cover that goes inside a glass lens .

The pictures are of what is called a Osha Knot they are reusable and you can buy new inserts .I use them on my M52A2 . they replaced tying a knot in the winch line on oil field trucks in the early 1990 around this area . A knot the tail chain pulls more on one side of the cable wearing more on...

This is a 9.00 20 on a CCKW rim it's not as wide as the m35 rim I see no rubbing on the drag link .

I tried to separate a set to make gin poles and ended up splitting the outside tube with a torch and replaced it with another tube . The rust was not real heavy but ran the full length .

If this truck has aeroquip or a rubber type fuel line the thin inside liner in the fuel line may have separated from the outside and is collapsing and blocking the fuel . When the truck is off it opens back up and closes off again when it has fuel being pulled through it .

I would check the linkage and make sure both sides of the shaft on the bell housing are greased .

I always hate setting a loaded trailer down because things can happen .In this case with soft sloping ground blocking is good thinking .

In the past I have used a wire with a loop on the end that will tighten when pulled . Put the loop over the axle hold it in with long screwdriver or a rod and pull .

Yes 21 1/8 inches to full mark. The multifuel in my 5 ton was always up and down when I changed to the no drain spin on filters it was a lot better .

When decking trailer I found that if you are using 1\4 inch self taping deck screws that a number 1 drill bit works very well .Some times when running down the screw it will bind and snap and waist a screw . The #1 drill bit will let the screw pull the board down and if it is over tight it will...

M 269 deck height is 52 inches beaver tail is 70 inches long and ramp is about the same . This has worked out real good .

You might try sliding each bearing on the axle one will go all the way and the other one won't .

Welded strap on torque arms on a trailer .I bought this trailer from a salvage yard in 2006 and rebuilt it every thing has been apart sand blasted primed and painted I reused all the torque arms I need to check them with a pry bar I did not see any of them touching or rubbing the strap . They...

Do you mean the clips that hold the window to the arms ? Memphis equipment window regulator clip #7529309 $3.23 each

Shell Rotella engines will look and be that clean .I'm not sure what other oils clean like that .

No I plan on just using it for parts .

.

Unloaded the trailer axles I brought home last week end Off of the m269. I used axle clamps and a tow bar hooked to the back of my M211.

Picked up some free parts today I'm not sure what military trailer they come off of . I know the wheel cylinders brake shoes and drums will fit the M52a2 and M131A5C tanker trailer . The man said he tried to take them to the land fill they refused because the tires where on rims he went to the...