Search results

Installed a new carb and it runs like a champ. Now i have another question on carb tuning. Manual says to turn the idle adjustment to 1/2 turn. The gen will race like crazy if I do that. I adjusted the idle until i achieved 60hz. Put a load on it and adjusted the governor to 60 hz. Then remove...

Are there any vendors there that specialize in MEP generators? I need a fuel selector valve.

i just cleaned again. can't get any cleaner. still takes off wide open throttle unless i choke it down. what's with the rubber washer around the main jet? it looks like it's seen better days. would that cause my problems?

Generator was running good last week. I was having issues with it not wanting to run with no choke, seemed like half choke was perfect. So I pulled the carb and did the standard clean on it. Put it to the 3/4 main and 1/2 turn idle. Started right up but over-revs until the bowl cannot supply...

hmm didn't realize that.

Yea i was going to install a disconnect.

This is what I currently have mep016 with gasoline engine. 220v welder at 25amp with a 50' extension cable with dryer plugs. House uses a gas furnace forced air pump and I beleive a 220v water heater. I want to make an outlet box with a dryer outlet and a twist lock outlet and a 10' pigtail...

I can bring a m105a2 trailer if anyone is interested in it. PM me if your interested.

is carnac going to have ground rods or ground rod kits?

Maddawg- You did great as a navigator!

I can pick it up at aberdeen, john said he should be there. Thanks for the offer.

ill be at sussex.

rc

Anyone have pics of that bronco being pulled out?

HAHA Good catch! HE LIVES!

https://www.youtube.com/watch?v=hjiNn3fdNCc&feature=youtube_gdata_player

https://www.youtube.com/watch?v=iYJBs56LMtM&feature=youtube_gdata_player https://www.youtube.com/watch?v=hjiNn3fdNCc&feature=youtube_gdata_playerhttps://www.youtube.com/watch?v=IOXuQoVUZso&feature=youtube_gdata_player

https://www.youtube.com/watch?v=B9ixwrs5khk&feature=youtube_gdata_playerp

is anyone driving past delta pa this weekend? I need something picked up at jcapplejr's house?

Rfischba1- do you have any sources for the rear canopy for your m1008? Ive been looking for one since last year when i saw your truck or a similar truck at sussex.