Search results

If you are talking about part 9 in the figure posted above my post mine was rotted as well.I simply removed it and replaced it with two small sections of hose.It worked,though I did keep the rubber piece.I tried to figure out if it was more than a connection,and did not seem to be.

Run a new ground(with out removing the old one)from the drivers alternator to the frame(8 gauge wire,ends,and a self tapping screw).Run a new one from the negative on the front battery to the frame as well.This solved my alternator issues.

Front battery is now at 14.7 rear at 14.6. Guess I should share how at this point. First my front brand new 31 battery had a BAD cell.This battery was literally a week old.I have heard of it happening,but this is my first brand new bad battery.So replaced the bad battery.Still had battery...

Still having a charging issue. 1.Today I took both alternators back off and took them to NAPA(yesterday I had taken them to Autozone).They both test perfectly.14.7V 0 problems with them. 2.Tested both exciter wires again with the key on and off.12.2V key on,0 Key off.The red wire on both...

I have read many threads on the site about problems changing the filters.All the problems had to due with air in the system.I did warm mine up before changing the filter,but I then did something I have not seen mentioned here. I put the new filter in a two gallon bucket and added enough diesel...

Try cleaning your fuse box.I had the same issue.I took all the fuses out and took a can of non flammable electrical cleaner and q-tips to the fuse box(there is really no such thing as to much cleaner).Unhook the batteries first,and wait until it is dry to reinstall the fuses.I waited an hour+...

I am now at a total loss on the batteries not charging. Today I took it to a mechanic friend.We followed the check list to the letter.All voltages where good with the key on or off.We did some continuity testing of fusible links.Checked all grounds.Pulled the alternators and tested them.Both...

Resolved a few things today. The horn issue is fixed(thank you Warthog). I removed the 12v bus on the firewall and cleaned it.I took some non flammable electrical cleaner to my fuse box. I used a good portion of a can with Q-tips and cleaned as much gunk out as possible with out removing the...

Amazon.com: Security Film - SecPRO Film / Explosion Proof Film Class 336 - 5'x100' 78lbs - Security Film for Home, Office, Store, Car, Commercial: Everything Else Just thought I would share.That is for a LARGE roll,they do sell in smaller sizes.

Thank you :) I will try unhooking the horn relay.Still at a loss on the brake lights and turn signals.I did try a new relay(i had one) still nothing.It is probably something so simple it is insane.Ill keep at it.

Checked for charging again with the key on and off.Both are charging.The new drivers side alternator is a new Delco one(the caddy one). #3. In the up position the horn blows,and the MAIN headlights are on(with the headlight switch pulled out,push it in and the lights go out but the horn still...

Fuse is good,and the blower motor works as do the wipers. I also have gen lights at start up,and the go out as they should.

First I have done the starter relay mod, installed a new GPR109,put in new 31 series batteries(with new cables),cleaned all grounds,cleaned fuse box,new drivers side alt(passenger is charging fine) and replaced all fuses with new.The truck runs and drives well. Now for the problems. 1.When...

A picture is worth 1000 words.I picked up an M1009 a few weeks ago and have run into a problem or two.Most where solved simply.Until I saw the picture in your post I was baffled even after looking and tracing voltage all over the truck.I had 0 power to the dash,starting at the diamond shaped...

I like it.I do not think you will need extra bracing.I may even look for the same type.

LMC Truck Parts - Page 12 That page and the following page are all the weather seals.

Link for the rebuild kit?

I received my power steering bracket today from Parramore Surplus Company .It is worthy of a picture.This was not a pull off bracket,but a brand new one.

I picked up bearings yesterday :) It is on the to do list for later this week.I have a friend with a shop(and lift) around 3 miles from my house,it should make it a pretty simple job. I am in Whiteland Indiana.

Batteries,Power steering pump(and line to hydro boost),driver side alternator,and other items are missing.I have a pump bracket,pump,and line on the way.I went ahead and started making some changes.I did the starter relay.Changed the oil,transmission fluid,and greased it. While I had the...