Search results

I would remove everything from the pump to the tank and clean it. I have a mep-025a that sat for years and the fuel line to the bowl was full of stuff that looked like brown silicone sealant. You can reuse the flexible fuel line fittings and just replace the rubber fuel line. I would just...

Does anyone have good data on the fuel usage for a MEP-016E under load..?

I eventualy found a replacement at Delks... Recently I have found them NOS on Ebay for $140..

Does it have a tow bar on the rear..?

I have a 002 & 003. My house is 1600 sq feet with central air. With the normal load, lights, computers, freezer & fridge it barely shows on either generator but when the air comes on it will push the 002 past 100% when it starts then settle down to about 90% and the 003 to about 50% so if you...

I have one from GL that I havent tried using yet...

With the power problems in the eastern US I'm wondering how many members have been running on MEP's the last few days. Post your circumstances, what your running, how long, etc....

I ended up using the air intake cover I had on the 002 I purchased last week. Andy..

Log splitter... Sawmill...

Its part of tm 5-6115-584-12..

I have had similar experiences. Amex will get you results...

The issue is a pattern of disrespect for their customer and a display of malicious intent, not a single mistake. Did your dad run away from things or take responsibility..? I was considering them but they are off the list now.. OP, Thansk for the heads up..

I used this in my MEP-003a ASK replacing all the insulation and it has worked very well.. Bonded Logic Heat/Sound Insulation - JCWhitney

I'm going to swap the engine in my 003 with one that was rebuilt. Any words of wisdom from those that have done this..? Anything to look out for.? Thanks, Andy..

If anyone is looking for an alternative to military I found these and just installed one into my 002. Works great. ISSPRO.com - Quality Gauges, Tachometers, Speedometers and more!

Very nice... I saw those were up but I was focused on other "hardware"

I drove it for the first time today about 50 miles. Much better then the springer...

I installed air assist for the stearing so Im going to replace it with a smaller\nicer one.. But it does help you grip it...:)

New hmmwv drivers seat...

I wanted to keep my bench seat for now so one of its legs would need to mount through a rail. I decided on the rear rail and just adjusted the seat forward. This gave me a little more room near the access panel to the master cylinder and I didn't need any in the back and your not going to adjust...