Search results

I have two with the Yanmar Conversion... Here is a engine parts manual for the one with the yanmar conversion.. http://dawinfo.com/L-AE-Series-Parts/L40AE-100AE-Parts-Complete.pdf Dealer Locator.. YANMAR | Dealer Locator As far as filters, etc the military may be using items...

Thanks, thats what I have been doing so Ill keep doing it..

I'm not sure if this is biological or mineral or some other type of contaminate but I discovered it in my 003 today while changing the fuel cap gasket. The cap has been lose for a while and I run off an aux tank so I don't open it very often.. Any ideas.. If feels like sand but turns to a...

It also got new paint...

Nothing like that. I was just wondering if it's better to set it to run at little <60 or >60.. Sounds like it's best for it to run no more then 60 and less is ok, correct..?

The insulation in the ASK panels on my 003 were badly deteriorated and didn't seem to work as good as they should so I removed all the old insulation and used automotive sound insulation to replace it. I used spray adhesive and I think that will work find for the sides but I may need to use...

I have tried using a 101 cargo but it really sucks if you have to work on anything. I have thought about cutting off the sides...

What is harder on the typical household appliance, high or low HZ..?

I had some time this morning so I installed a new ASK on my 002. It really does make a big difference. Quiets it down quite a bit.. Took about 4.5-5 hours but I did trial fit it several time before drilling anything.. Now I need to find a M116 trailer for it.. ETA - They even painted the...

I have a oil leak that looks like it is coming from the governor shaft. I am debating if it's worth the trouble to remove the gear cover. Anyone know what the packing is made of..? Is it compressed when assembled so that it cannot be removed and then reused..? Thanks...

Welcome to the addiction....

I ordered a replacement & spares from Delks. I don't want it to go out when I need it the most.. Thanks for the help.. Andy..

Am I reading the Winch LO correctly. 1 1/4 pint in the worm gear side and 1 pint in the other..? When I drained it, it had much more than that in it.. Like a half gallon or so.. Does overfilling create any problems...? Thanks, Andy..

Ok, I carved one out of balsa wood, drilled two holes for the magnets and gave it two coats of epoxy resin. Works like a charm..

I really like the outlet box idea.. Think Ill do that to my 002 & 003..

The float is solid but saturated with fuel so it sinks.. Anyone have this problem before..? Delks wants $120 or so for a new unit so I would like to find a way to fix this one... ETA: Idea. Im going to make a new one out of balsa wood and coat it with epoxy...

Same here.. I pealed off all the old brittle rubber and taped it good..

Now.. you may be on to something there...

I have it working, thanks to another thread, just needed to clean the spark plug... but the ignition cable is very worn and I would like to replace it. Anyone seen any place that carries any parts for the flame heater..? The cable is part number 11641776.. No joy on google...

Tank float doesn't float.... **Does Now** While troubleshooting the aux fuel system on my MEP-003a today I discovered several problems. One is that if I remove the float switch from the tank and raise or lower the float it works fine. But it will not rise in the tank. Anyone ever run into a...