Search results

I was just going to say the same thing, Check for loose wires and contact Kloppk. Too me it sounds like a loose wire that just can't carry the field load after a certain point.

Install separate meters for each leg. If you want to modify the unit that is the easiest and best way to get what you want without changing the wiring.

At least you know you lost these hours. It is all the hours we lost in younger years that we don't remember!!!!!!

GMG says they have the manuals but I do not see anything but specifications on the linked site. https://greenmountaingenerators.com/manuals-and-support/mep-009a-mep-009b-mep-108a-manuals/#google_vignette

Are you running the lathe through a phase convertor or are you powering your house with three phase? You mention the 240 for house and garage but show 3 phase connections and mention the 3 phase lathe.

2900.00 plus 13% buyers fee. 3277.00. Still a LOT of money for a 28 volt genset of that size. With an engine that drinks fuel at what I am sure is very high rate.

They are selling on the net for 14,000.00. That is one big chunk of change for "a neat engine"!!!

That must be quite some operation using that much generation capacity!

It's not over full is it?

I just bought the LiTime batteries for my RV and they seem to be working well. That was why I was curious.

What brand of batteries did you get?

Were those two cut wires twisted together? I am not all that familiar with that machine but on the 003 and 2 that would be an oil pressure safety switch. They are known to go bad and engine will not run due to a perceived lack of oil pressure. Your gauge is probably wired through the electronics...

I think the main issue would be connection the engine to the accessory. From what I have been told these have a unique flywheel arrangement. I have a 23 horse Kubota engine I would like to put in something. A bit overkill for my log splitter though. I actually thought about using the Kubota on...

https://www.youtube.com/@JustRolledIn There are some real classics on here. I saw a lot of them when I had my shop but some are simply unbelievable!

Nice, I will definitely be watching this since they just announced a 25% increase in my electric bill. On top of multiple 2-3% increases per year for the last 5 years. Beautiful house. Well thought out with the sun exposure through the windows and wood stove.

Welcome to the nuthouse. You are sure to cringe at some of the installation stories and methods discussed here.

Most of the time a hard to remove filter was installed far to tight. An automotive oil filter is hand tight plus 1/4 turn. I have seen guys tighten it with one hand and then grab it with both hand and turn it an addition 2-3 turns. Most of the time they just use the same removal tool to...

I have run into that with oil filters on cars. About the only way to have a completely dry oil filter gasket is to clean the gasket surface and surrounding area with brake cleaner. In some of those cases I had to resort to a torch to heat the base (That was all that was left after tearing off...

I have an 002 and it is plenty stable. Set the trailer brakes or chock the wheels and it will go nowhere. You absolutely need to bolt it to the trailer or you are asking for it to slide right off. Metal on metal is like rubber tires on wet ice. No matter if it is two or four cylinder it s...

You will have to PM Mike on the details. I am pretty sure at least one of those times it was a civvie stove. All ribbing was in jest and while he was a bit perturbed at first it ended up with all involved getting a good laugh. The best explosion I saw (outside of active duty) was at that same...