Search results

Looks like we got the same dusting you got. everything here is fine except I could use about another 50 degrees of heat!!

All we got here in NJ was a very light dusting.

I am a bit confused about the line connections. The aux pump will not pump any fuel if it is not connected to and external fuel source. Hooking a line up to the outlet should in no way get fuel out of the pump. Several things here have me confused. The fact you are getting varnish out of the...

Blow out that fuel line form the tank to pumps before hooking up to be sure there is nothing in there that will start the whole problem over again. And are you getting fuel out of the return line with the pumps running and everything hooked up? Will not be a lot but a small trickle back into the...

We have gotten very little snow here but man has it been cold and windy. The wind has been blowing a solid 20-30 mph for well over a week now with gusts over 50 mph.

(y)(y)(y)(y)(y)

But are the wires connected to the gauge output or the 110 input to the transducer? I am thinking that since this controller is designed to be used on a Generac set it would sense frequency from the 110 volt output of the genset. In out case the convenience outlet. I seriously doubt they use a...

Looks a lot bigger when in your hand. I have seen people use small cords so many times on generators and RV's.

Looking at the directions I see the controller needs 12 VDC and the frequency is controlled by the AC output. Where is the 12VAC needed?

Nice, since my vernier function on my cable on my 002 has seized up it can be a pain to get the frequency set right. That might be an option.

Your running 50 amps through that extension cord?!

THAT is why I like my old 00X machines. No electronics to tell the machine what to do other than an overheat switch and and oil pressure switch. Both very easy to check/bypass if needed.

I would run your pressure tests again once you get them cleaned and back together. I have also not seen that type of plunger, looks like a seal of some sort. If I had to guess I would say it may have been replaced and the replacement was from a different contract and different company. As far...

Ray, he did mention it ran out of fuel while doing a load test. while showing 1/4 tank and then light came on. Sounds to me like the the light is correct and the gauge is not.

Does it show full when it is actually at 3/4? May need calibration or it may simply be a bad sender.

I would also be interested in a couple of the overlays.

Fixing till broke is a lot better than running till broke and then fixing. That is unless your fixing is what broke it.

I don't know if it is in the TM, probably just never paid attention to that since I have run into that same issue on vehicles and trucks that go from normal weather into extreme cold. If it is something that will be out in the cold for long periods I will use graphite in the bushings and shafts...

And if you test the starter with it removed be sure to have a good hold on it (nowhere near the moving gear). It will want to jump pretty hard. In other words, be sure that you have a grip on it and it is not laying on top of the batteries. Put a heavy clot between the starter and whatever it is...

Very good point on low batteries. If they are marginal then the glow plugs will drain them to a no start condition. And like Scooby I rebroke ribs from pushing the limits, also did the same with an arm at a different time. Yea, I am one of those that didn't like to listen to doctors advice. I...