Search results

That would work, you could also pick up that "signal" at the trans relay which would be more convenient as usually the inverter is placed in the battery box. I have seen unused #29 leads (switched 24V) near the trans relay that would be very handy as an "on" signal to the inverter.

I would not power the inverter off of ether source, if it will not allow remote switching as the Orion will then I would use a relay controlled by ether of your listed sources. There is switched 12V at 290C and switched 24V at 29T at the trans relay, there is possibly extra # 29 wire not being...

There is also a company selling a kit to convert the OEM switch to keyed operation, not cheap but pretty cool, but I don't have that info...

Yep, missed that:eek:

Since the starter was not pulled it is unlikely they got the pan off. It is possible someone just needed some pan screws.

You have a bunch of redundant photos posted, you should go and edit them out.

The incandescent lamp is an 1873, 28V 6W

Have you put a want in the classifieds? there is allot of surplus stuff in PA

The LED must be wired internally in the reverse compared to all other lamps, the body is positive and the tip is negative. To be honest I do not see the big attraction to LED lights, if it were me I would just put an incandescent lamp in there and be done with it, incandescent lamps worked fine...

Welcome to the SS forums!!

You may want to contact Novak conversions as they know more than most folks about transfer cases and sell master rebuild kits.

I would assume many of the parts would be the same, the Jeep 242 and the GM 242 (Hummer/Humvee) are close but not identical, the Jeep version has 5 modes where the GM version has 4 (no 2wd) The GM version has larger splined input/output shafts, not sure if that translates to different bearings...

The only way to correctly do it is to flush the entire system (which should definitely be done if the system was open to atmosphere for any time) then drain and refill the compressor and add the additional amount required by the system. Replacing the drier is a must do just before evacuating the...

Yes

The neutral switch has nothing to do with the IP signal, only the start signal

Do you have power on #29C to the EESS box? you say the wait light stays on, do you mean with the run switch on or all the time? Have you checked the voltage to the glow plugs? Do you have a good schematic for your truck?

The detents as mentioned above are internal to the transfer case, if it will not stay in gear it is internal damage. This is why we constantly tell everyone to change ALL fluids and filters as soon as they get their trucks, that is an expensive lesson to learn.

Welcome to the SS forums!!

I was riding with a young man on a Houston highway when he felt the steering "go away" as we started to hydroplane, he immediately planted all 150lb on the brake pedal, so here we go heading straight for the barrier in a Y in the highway, I had to repeatedly scream at him to get off the fn...

Put the standard bulbs back in.