Search results

Ok. I think i got the wiring right. The slave port now shows 24v. The generator has two alternating yellow lights. I have to wires in the pic below that i dont know where they go. The one with the terminal has 17vdc. Weird.

Yes, the only long cable that comes from under the cab is the ground.

Eaxtly. I have a long cable coming from the cabin side and 3 cables coming in from the disconnect box. I have seen plenty of vides and dont see what i have. Mine came without the cover so no diagram and i believe it was missing 2 of the positive to negative cables. I managed to get 12v and the...

ok. Let me study the diagram and ill report back. Thanks again.

I want to run 4 batteries. I have already bought the 6tl's. Id like to keep everythinh as stock as possible.

Howdy folks. Im getting ready to fire up my first m1078a1 but can seem to get the battery wiring right. My battery cover with a diagram is missing and some of the cables were missing too. Manuals for the a1 are not available and my unit has a battrry disconnect not shown in the diagrams of tha...

That was fast. Thanks alot.

Howdy. In my 1078a1 I have one chamber that lost the bolt that unlocks it in case you need it towed. Where can i find one?

Im game!

"knowledge is power". Thanks alot Cucvrus.

I once saw a half a backplane on auction on gov planet. It was literally half a board. 😂

Three options available. What would you consider to be zee best? https://www.summitracing.com/search/part-type/flexplates/make/chevrolet/engine-size/6-2l-379/ring-gear-tooth-quantity/139-tooth

No, i did not know they were one and the same. I also did not know that i could replace it without dropping the tranny. Looks like ive got some reading and ordering to do. Thanks alot guys.

So im probably gonna get a new flywheel and flexplate and save them for the day it all craps out. Then just get the starter rebuilt and do all at the same time.

Howdy folks. My starter sometimes cranks but the engine does not turn over. I took off the clutch cover and found that in some parts of the flywheel there were areas shaved off by the starter not engaging fully. Since I bought it, the m1008 ocasionally does it but otherwise it starts right up...

Someones gonna buy a bad backplane soon. 😬

240/416 setup is being reigistered by the CIM. Check the connection board as you might just need to switch it back to 120/208v.

By looking at your pic, it seems you have an 816b not a 806b since it says 400hz, but you have an avr 100 module that is used on a 806b. Send a pic of the manufacturers plate for reference. Also, check the voltage selection toggle swith and make sure its at 60hz. Only move it when the unit is...

In a side note, what is this cable for?