Search results

If fuel is leaking out , air is also getting into the system , so yes it could cause the rpms to fluctuate , but more likely will cause a hard start. I like using push-lock fittings with rubber hose rated for fuel , the original cost may be slightly higher than a cheap hose but the fittings are...

Didn't you like these replies ? New thread 15 minutes after staring this one. M1045A2 year 2000 what engine? Started by Bravojmc, Today 12:02

From the post above yours it sounds like if you give big block 88 a forklift he can make room for 10 more . :doh:

Test Your EESS box. Have you downloaded the free TM's ? They have troubleshooting sections in them. TM's for the M998 seriesA good source on how to use the TM's; How to use/read Technical Manuals

That thread shows up in the 6th hit searching google "LMTV convoy light connector". That's why I suggested changing your search terms to the military's name for the light...

TM 9-2320-365-20-3 section 7 cover's the PDP Post #5 of this thread has a link to that section https://www.steelsoldiers.com/showthread.php?124517-M1078-No-Start-Not-even-trying The rest of the TM's can be download free here; Listed below are a number of the TM's for the M1078 trucks. To...

You might want to check over at M715zone . http://www.m715zone.com/vb/index.php

https://en.wikipedia.org/wiki/List_of_U.S._military_vehicles_by_model_number

No shop air to charge the system with ?

Try searching using "convoy light" instead of "strobe light".

It gives you time to do your daily pre-trip inspection.

A lot of tire shops like using torque limiters on air guns , but you can't beat a quality torque wrench .

That would involve actually opening and reading a TM , which rarely happens until they trash something.

He updated the rules on that thread and you need more than one post now.

No I haven't used this particular electric winch , but have busted every electric Warn or Ramsey winch we have had. They may have come a ways in the last 10 years or so I don't know . I've been less than impressed with the hydraulic winches then also . The D6 cat I used to run we would snap 1...

That could be a problem . There is a frame number that in the VIN . I sent you PM with a link to a good article on the M35's.

...............

You don't have to tell me , we have all kinds of fun with 11 axle gravel trains here.

And if it's a outside dual that's flat with the 4"x6" block to drive up on you don't need to bother with a jack. Of course Murphy's Law usually kicks in and the flat is on the inside.

Why not just take a pair of good batteries with him ?