Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
That's kinda what I'm thinking. I would use a 3/4 steel drop plate that would be welded to the pintle assembley. It would be an inch wide on both side of the pintle and drop down below the pintle about 15 inches then cut a 2.5 inch square out and insert the hitch. Then make to more plates with...
Well I'm thinking about a standard trailer hitch install so I can pull about anything behind the truck. Since its a tractor normal solutions won't work. I've seen a couple of ideas that put huge plates on the back of the frame or alter the trailer itself. I'm looking for something that will look...
Your fail safe warning box controls those. Eriks' has them. They are located by your left foot sitting in the drivers seat on the side panel almost under the dash.
I had to replace mine, the warning was on all the time.
Don't know if there is a rub issue. Most do the upgrade because its inexpensive, looks good and gives you about 4mph more for a little better cruise speed.
Mine is a 71 American General. The power loss is a little not too bad. Road speed went from around 47 to 57 mph so its good going down the highways here in the US and not cause traffic issues. The bigger tires and wheels didn't make the steering that much more difficult. You just need to be...
The deuce forum talks about the wiper set up, can't recall I'm traveling now just do a search and it will come up. Its widely discussed.
The converter I got I connected directly to the batteries with an in line fuse.
I wanted 15 amps min so I could run a laptop if needed. I don't remeber the...
I've done even more on my Deuce
I don't think there is another like it in the country.
Big mod's on it:
Hemmtt wheels with 395 tires
Gun mount and something to put in it !
Air O matic steering
EGT and boost gage in a custom dash
HMMWV drivers seat new steering wheel
Lock out hubs
LED's...
I though I might summarize in one post what I've done to the truck the last year of ownership:
Installed coolant filter system
Fixed four leaky tires
changed tranny fluid over to Dex 3 and linkage adjustment
Replaced right front axle boot 3 times
Replaced right front axle oil seal
Installed...
Here's the link to what I did: http://www.steelsoldiers.com/showthread.php?82926-M932A1-with-shorter-drop-side-deuce-bed
Check the 5 ton mod section. This is a well covered modification. Good luck ! The forum search function can also help a lot.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.