Search results

can do. I will get right on it.

I don't think napa is going to have them. try the normal sources like mil surplus dealers.

if there is enough interest I can have them made.

have you asked mike? he seems to be the go to guy for MKT parts.

The gun most likely would have been a M2 but could have also been an M60. does your cab have a plate behind both seats spanning the width of the cab?

call a dealer for a replacement. or you might get somebody on here to sell you one. I would never reuse an oring.

the pulley would be the only difference.

ebay. it's where I got mine. good place to start and get a rought idea on prices. dealers will rip you a new one on prices.

if you want your speedo to indicate correctly with hemtt tires you need the hemtt speedo adapter. if you want your deuce with 1100's to read right then use a 5 ton adapter.

hemmt. just like the topic says

I'd like to know how and what airbrake setup that is. very cool. I would bet lunch money seco built those.

I got one from a member on here. otherwise I'd start calling the dealers. it made my speedo work perfectly, it just doesn't go high enough anymore. I can do 70 with the big tires.

I was hoping you meant georgia, usa. my bad... :(

very good point. had not thought of that.

if it were an A3 you'd also get the 3 point seat belts and would have had an insulated floor and no provision for a clutch pedal. very cool anyhow. FWIW there is an additional small cab plate that mounts to the rear mating surface where the original hard top would go. it's more or less a...

all the A3's came with the plate and it's a great way to stiffen up the cab of any truck. with or without the ring. it should be about 100 rivets and yes you can drill them out.

don't think there is a civy part, mil surplus only.

what does your egt do when you hit max speed? it it goes down then you are not getting enough fuel. I would go thru the TMs and make sure the gov is set correctly.

that plate in your last pic is std. my truck came with it and most I have seen have that one. there is a vid on youtube of firing a 50 cal off a deuce. when I find the link I'll post it.

be very careful taking it back. you might have gotten lucky driving it home to not torch a bearing running it dry like that but going back you may not be so lucky. you can put cork or permaseal in the keyway, either is fine as long as it seals up.