Search results

I don't have the bracket from the feder to the pipe either. I would think it would cause problems when the engine torques over or the truck flexes on rough terrain.

Ace, How many pages is the Mack engine TM? If it's no too big, I can scan it and turn it into PDF.

Dang! Didn't think to use the emotion thangs.

Try Idaho Motor Pool. They 're up by you. Or down here in Ca. Antelope Valley Truck and Equipment or Barstow Truck parts. See if you can find a copy of Military Vehicles Magazine. There are lots of advertizers there. Good luck. Snap a picture of what you need, sometimes people here have them.

They like to vibrate a bit more than I like at a speed below 700, also it helps out with the low end acceleration.

700-750 for idle. Yes, there is oil in the AFC area.

That's repairable! rofl

Here's another. This is what happens when you have NO pre or post use inspections and employees are stupid and can't see coolant on the ground. This WAS in a generator. It was a mechanical engine with a low coolant level sensor installed...they won't work if the bulb isn't in coolant! it was a...

Bruce, I say nay on the parts availability. Parts for the C are very easily had. If you need some and can't get any help, please let me know. As for the power, although they are almost the same HP, 250/290, there is no substitute for qubes. Torque is about the same, but I still feel that the 855...

Ahh, open wheel racing, it's a dangerous sport, but someones gotta do it!

You have a very nice looking truck. Did you do the sprag without taking the t-case out?

RE: trucks Millenium Reo? Whuuu?

Accidentally...ON PURPOSE! I'd do the same thing. Looks like they were lovin' it.

RE: Parade ready for tomarrow! CS, nice rig! Make sure you get some pics snapped of the parades.

Did it feel like you had power steering with all the weight over the rear?

That truck looks new! Wonder what it's got under the hood? I've seen the bar mounted on the grill somewhere before.

Do you have the NSNs of the bearings, std and undersize? I am going to a place maybe next w-end that has a whole shed full of NOS bearings, roller and engine stuff. I'd like to find a mess of them for the multis.

maybe try bon-ami cleanser or comet.

Any luck dropping the pan yet?

That sounds like a good price for all the trimmings and especially a '96. Does it have a title or is it plated already? Got a truck to pull it with? Welcome to Steel Soldiers.