Search results

Start with TM9-2320-387-24P. It’s by no means comprehensive of the myriad of configurations fielded.

Heat it up with Victor wrench. Never fails to convince stubborn threads.

Hawkers are great but 13 years sitting dead will likely have killed one.

I have looked everywhere and I cannot find the drawings. No big deal though, the wood blocks are 2x4 true dimension white oak blocks that are the same length as the 299 feet. You will see that the 299 hangs over the sponson, these blocks accommodate that. The mount should allow about an inch...

Your problem is new loads of crap being pumped out of the tank and holding the needle valve open. Put a filter before and after the fuel pump. Carry spares. When the truck won’t go 60 mph anymore it’s time to replace filters.

let me know if you need the signal corps drawings of the wood mounting blocks and location on the sponson.

Need you to triple check the connection of the wires to the ignition switch.

What happens at this point if you move switch to start?

Your trailer does not appear in any of the usual military equipment reference manuals.

That is metric.

Where did you disconnect the starter trigger wire, at the starter or at the ignition switch? When you did this, did the instruments come on in “run” position?

Sounds like the wires to the ignition switch are not in the right place.

No. Rent a 580K for a week and spend your time digging not repairing.

Almost always rain water. Pro tip: don’t buy the units with no exhaust flapper in the pics.

Pressed on the rotor. Not one of Dana Corp's better ideas but it works.

Not sure about your neck of the woods Drew but here in the Houston metro area, driving around with mounted weapons results in dozens of 911 calls and a bigtime butt chewing from the popo.

Yeah that dude used to post on here but it's been a long time. I can't remember if I called him out for his practice of driving around with mounted weapons fake or not. That has always been a huge nono in this hobby. Really freaks people out.

Pic is funny as can be. In the pic, I see what looks like a rusty steel semicircle pointing up that seems to form a skid under the centerline of the shelter. I have never seen a S280 with a steel skid like that, only aluminum runners. If the rusted away steel skids are non original or...

Looks like the Go Dov chapter in these truck's lives may be over, Eastern Surplus & Equipment ( a supporter of this site ) just bought (the remaining?) 60 of these ... Good luck Dave! Quite a commitment.