Search results

Picked up my Deuce at Lackland AFB today and drove it 70 miles home averaging 40 to 50 MPH. Got a few leaks to address and I will post pictures later on those. First I need to address these items: My oil pressure gauge does not move when I turn on the engine but pegs all the way to the right...

Are there 3 or 4 steel bow rods on a deuce soft top?

Are the 3053 and the 3053a the same (5 speed overdrive). I seen for sale posts both ways.

I am picking up my M35A2 tomorrow for the 60 mile drive home. I have test driven the truck twice but still want to go over all the fluids prior to setting off. And yes, I have searched and read past threads and the TM's and LO's until I am half blind and very frustrated. So....here goes: 1...

Cleared the air tanks and the buzzer went off as soon as I turned on the switch. Held a steady 95 to 100 psi during my test drive. :driver:

I rechecking a deuce tomorrow that I am hoping to purchase. When I first test drove it, the air pressure buzzer did not come on when I turned on the switch. I will look at the pressure gauge but want to know if there is another way to check to see if the system is pressurizing?

Super input. Thanks all.

No Carnac, and missing everything between the round flange on the PTO and the small shaft coming out of the winch.

I looked at a deuce with a front mounted winch that is missing the propeller shaft assy. It has half of the front yoke attached to the winch shaft but is missing everything else up to the PTO shaft. Any idea where I can get these parts?

I need a deuce checked out at the GL - Corps of Engineers on Grant St., Peoria on 8/31 thru 9/2. I would be eternally grateful. :D

Missed you by one day. :cry:

Most of the M35A2's posted on GL have a H7 classification and I have read their definition but am confused as to exactly what that means. How many of you purchased one like this and found the condition to be okay. Particularly, to get it off the lot.

I have been thinking of bobbing a deuce and want to use the original wheels and tires. I would also like to keep duals on the rear axle but utilize a deuce front suspension in case I want to go with larger tires later. Finally, I would chop the existing bed. Any issues that would make this...

Don't know about rental but what are you looking to blast?

The trucks nice but I'd take the kids.:D

I participate in numerous forums and this subject comes up often. I do not see why everyone get their panties in a twist when someone asks a question. I have tried searches and have had little luck and then started a thread only to be scolded. Bottom line is you are not required to read or...

Past Bid History I go on GL and create a watch list for vehicles I am interested in. I also write down the Event and Item numbers to check back on the past bid history since GL does not transfer watched items to a close watch list like they say they do. You will be able to see the whole...

Will GL permit you to inspect a vehicle you purchased and paid for but are awaiting EUC approval? Would make recover planning easier.

I purchased a M-Series receptacle cover shown below. I had planned to install it with the cover flap lifting up but the writing on the cover plate is upside down when installed that way. Is it supposed to open up or down?

Anyone know where I can find a gasket for a Multi Fuel water pump? I have tried Saturn, Erik's, Ebay and C&C. Thanks.