Search results

Same hole pattern.

That trailer...M101A2 is to heavy for a jeep unless you have an older one with a V8. The M416, and M100 trailers are perfect for a jeep.

I have a 86 rolling frame I was thinking about selling. Its in So. Cal.

The Pass side has a two piece shield. I might have a spare set.

I hooked up the speaker output of a stereo to the spring loaded terminals and found that volume was low, until I turned up the stereo volume.

Engine is same physical size in all Humvee's, but the cooling stack is longer. And some have gear drive fans.

What is the part number and color of your PCB box ? And who makes it ?

Or three sets....or more...:)

Box could be bad...but i had that once when I changed a box....I added a ground wire from one of the PCB bolts, and went to the Gen. ground lug. It worked after that. Sometimes when light just flashes...turn it off, wait about 2 minutes, then try again. These trucks should have a bunch of ground...

There is the Shakespeare SF3512/VRC which is 30 to 512 Mhz. I can get used ones.

Get rid of that old Nartron. SSI is good, KDS green and Yellow with sensor is good. Nartron new style has a yellow label and takes the same sensor as the Yellow KDS. There is a KDS white label out there, and a KDS smart start also.

Tm9-2330-202-14p Fig. 6 says : 11686101, 69" long...used on A2, A3, quantity 1 15641501, 74" long...used on A3 only, quantity 1

They only go on the top, and later A arms have them already welded on.

There is two types : deep water fording...25043364 standard non-fording.25042462

The A2 trailer wheels are standard Chevy 8 lug wheels as on all 1 ton and 3/4 ton pickups up to 1987 and 1 1/4 ton CUCV's 1984-1987.

Replace shock...# 1844-2 I got one from Croft trailer.

If you have a M101A2, use the same tires/ wheels as the M1028. If you have an M101A3...those are normally Humvee tires..37", on 8 lug, 12 bolt rims and expensive, hard to balance, and heavy.

Thanks for the info.

I'll check to see if i have an extra.

From the radio mounting base attach CX-13313/VRC vic interface to J3, and out of interface, connect a CX-13300/vrc cable to J501 on AM-1780/vrc amp.