Search results

The one he is talking about is not a 2 stroke Detroit. It is a 4 stroker, nick-named a ""fuel-sipper".

You guys are no fun. I was liking the too many amp thing. Given your climate, I would go buy 2 new group 31 batteries, update to a modern gear reduction starter, and be done with it. Batts are $100ea and starter can be had for about $250. Starter pulls 50 amps less current, has consistent...

I'd like to buy a vowel.

Most of the technology statements here are incorrect.

Somebody probably just has it turned up too far. Adjust fueling to factory spec and as long as the engine is healty in all other regards, it will clear up. They don't smoke when running correctly. Slight haze on hard acceleration is the most you should see. Any more than that is just wasting...

Ha! That's awesome! Egg on my face. Well bring it anyway. Now we have something to laugh about.

Congrats! I'm thinking about organizing an off road rally this summer if you are not scared to get it dirty. Let's see if the winch works.

Meow...

OK. Thanks and sorry. If somebody has the right part number, please post it. I have tried to look, but it se ms the alternators were installed at the truck plants, not the engine plants, so that means it will be a Kenworth, Freightliner, etc part number, not a Cummins. But Cummings may have...

Hi Derrick, that Honda is an expensive engine. Any chance you can use a belt driven hydro pump on the engine, or a PTO off the trans?

Not sure they can. The only relief may be that you don't have to buy 3. How much are the ARB 2.5T air locker units? $1000? When I developed the 8.3L A/C compressor bracket kit, I brought it to market for less than half of the Kenway / Red Dot kit. Nearly 1/3, actually. My plan would be...

5t air locking axle assembilies are $1000 each in the market, sold typically only in lots of 3 and at a 5.88 ratio. So, the number to beat is $1000 per.

I think those straps are seperate short pieces that attach with a single screw into the bow corner? They make look broken but loop back on themselves? Can probably just get a few replacements if need be? I have yet to roll mine up on the sides, but heard it may be easier to do using a long...

Yes.

M35A2-AZ, nice job on the mount! That's a beautiful solution.

I think the military used that same alternator on nearly any vehicle that was not dual-voltage. Recommend to keep your pulley until you have the new one in amd working. I think the 250 engines have an alternator pulley that has more stand-off to it than normal, so if you meed to have a machine...

Your truck should have abs, and therefore an air dryer by the mid axle. I serviced mine once, and I have not drained a single drop of water from any drain after. I actually gave up on opening them because it seems to be 100% effective. Everybody will tell me that is terrible, and that is...

Low cost replacement part @ NAPA. Volt adjust screw is under an Allen head cover screw by the wire connection cover area if I remember right.

It is not charging. 25.6V is standard voltage for full charged batteries in good condition. Anything over 25.6V is charging.

Not really. It is just making a badly designed system correct like it should have been from the beginning. If they would have placed the battery disco switch elsewhere in the truck like other vehicle makers do, this would not be such an issue. By upgrading the starter and alternator to modern...