• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. m-35tom

    Who is going to Red Ball in Gilbert?

    frankenstein od trans back in and bed on, just some details now so will see you sick people on sat. tom
  2. m-35tom

    HEMTT seats in a deuce...

    seats in deuce, i made a plate the same size as the spring seat base and mounted tubing on it to mount the seats to. very easy.
  3. m-35tom

    2.5ton bobed rear suspension help

    that looks very dangerous, i would be careful even getting under it
  4. m-35tom

    HEMTT seats in a deuce...

    hi dan, i'm 6'3" 250 and have plenty of room but also have smaller wheel because of ps.
  5. m-35tom

    Custom oil pan on LDT-465

    the oil pump is in the front and has a scavenger pump that moves oil from the rear small sump to the front for main pump so there are 2 pickups. look in the engine manual for pictures, you should have no problem reversing the pan and modifying it but you may have to disable the scav pump
  6. m-35tom

    HMMWV alternator on Deuce voltage too high?

    if normal charging is 14.4 volts per each battery that is 28.8 volts accross both, does not sound like a real problem. what is the voltage with load like lights on?? sounds like you are ok. i would like to see close picture of alt and wiring
  7. m-35tom

    Transmission noise

    RE: Re: RE: Transmission noise well i have what i know is a good trans because i built it and it is quiet all the time and very easy to shift, even hot which is about 150f and goes back into 2nd at 10 mph easily. of course it shifts slowly compared to a car or light truck which it is not. it...
  8. m-35tom

    Re-Powering The Deuce With A 5-Ton LDS-465-1A Engine

    monty, the 3208 is just a very noisey engine. the fuel knock is very loud and i had to have hearing protection not because of the exhaust but because of the engine noise. i had a new engine and we chased the noise several times even changing brands of pistons. but as i said i had a stock ldt...
  9. m-35tom

    Transmission noise

    the 3053 is a very quiet easy to shift transmission. any noise indicates serious wear.
  10. m-35tom

    tranny lube?

    when i talked last week with the tech department of TTC who now handles the spicer trans products, they said that 30 to 50 wt motor oil was completely acceptible for the 3053 trans. i also use it in the transfer case. as to oil leaks, with new seals (not nos, they are no good) i don't have any...
  11. m-35tom

    Re-Powering The Deuce With A 5-Ton LDS-465-1A Engine

    right jeff, it's the same size motor and i don't think from a practical point it makes any more power than a 'turned up' ldt and i've had both. dual stacks and twin turbos............. now where can i find a 9 litre international??
  12. m-35tom

    deuce running cold?

    everything on mine is new so i assume it is typical of what is expected. runs 160 all the time regardles of load or outside temp. however most diesels perform best with high water temp, 200 would be ideal
  13. m-35tom

    Problem getting my new deucee to run right.

    n1vbn wrote: The DEUCE fuel tank pickup tube is set to leave 1/4 of a tank of fuel in case it is contaminated. All deuce's are set that way from the factory per Army spec.. Jim that's just not true. it might be refering to the pickup tube for the fuel burning heater, but i imagine it is set...
  14. m-35tom

    Problem getting my new deucee to run right.

    does not take much time to remove two screws..................
  15. m-35tom

    Blinker problems on m35a2

    RE: Re: RE: Ground is good something not mentioned is, do the 4 way flashers work and do all bulbs light then?? if they do this would indicate a bad turn switch.
  16. m-35tom

    info on wiring harness numbers

    also in the manual
  17. m-35tom

    Blinker problems on m35a2

    RE: Re: RE: Ground is good will, we are just checking for voltage, not resistance. a meter will show voltage if the circuit has a resistance problem because it does not load the circuit the way a test light does. if the socket shows voltage with a test light, the bulb will have power. then if...
  18. m-35tom

    Blinker problems on m35a2

    RE: Ground is good it sounds like you are saying that you have checked the wire to the light and it has power??
  19. m-35tom

    Blinker problems on m35a2

    RE: Ground is good use a test light, not a meter to be sure you have power. if you have power the only possible solution is a bad bulb or bad ground
  20. m-35tom

    Problem getting my new deucee to run right.

    pull the cover on the shut off cable and see that the rod going to the rear moves very freely. then give it a healthy dose of diesel fuel additive/cleaner
Top