Search results

This would be for those that have a parts machine to cann from. Thanks in advance! 1) 1 ea D ring and hardware for the control panel end of the machine. 2) 5 ea nut & bolt w/washers for the lower edge of the fuel tank panel. Sent from my SM-G970U using Tapatalk

After an unmotivating winter, I'm making another attempt at this project 802 I have. There was a noteworthy list of problems when I got it, and I'm starting to see the light at the end of the tunnel. It's a smooth running machine, up until I attempt to go over 74 PRC on the AC Ammeter, then it...

My searches come back with little to no related TM/TBs for load testing these units. I'm sure most load bank equipment has their own TM, but that's not what I'm looking for. I've done my best searching the maintenance TMs and Operator's manual to no avail. Is there guidance specific to these...

Some time back I recall some fellas telling about their mod to use a loop of rubber rope (IIRC) on their covers inlieu of the braided rope from the factory. I understood that the rubber rope did a better job of keeping the cover more taught and was much easier donning and doffing. Despite my...

I've recently noticed that any/all notifications have stopped coming to my email from the site. I've verified my profile preferences/settings and all the boxes are checked. I'm at a loss for how to fix this. On a related note: I usually interact with the site via Tapatalk, and all notifications...

Preface: I was drafting this as a PM to @kloppk when I realized the knowledge shared/gained would be better served as a thread in case someone else could also benefit from the knowledge. Cheers! I find myself once again wrenching on yet another 802. This time my troubleshooting brain thinks...

As I've mentioned in past posts, I'm a Squarebody kid...so my joys are found in increasing the versatility and resiliency of my "old trusty rusty bucket'o bolts"...of which the CUCV world has given me much to ponder on. 2 items I've recently come across that peak my interest are some...

I'm studying the TM wiring diagram to answer a theory question that stems from my brother's commercial genset. It is understood that the Neutral bond must be disconnected at the lugs (in most cases) to feed a structure service as NEC requires the Neutral to be bonded "at the first disconnect...

Been some time I've been wanting a sibling set of 802 and 803 units mounted on 116A3 trailers...the 802 being most desired ATM. (Last summer I brought home an unmolested 101A3, it needed some TLC so now I have spare parts for both trailers.) Back in Oct of '20 I found this 802 in Phoenix when...

Along the way I've added a CUCV component here & there to my 78 K25 as I find they give added versatility to my multi-role monstrosity. (Rear bumper, bed tie-down eyelets, etc...NP208 PTO is likely a pipe dream) My current consideration is adding the multi-point electrical distribution blocks...

Came across this on fleabay. Can someone elaborate on the cause/need/fix/solution of this kit? Sent from my SM-G970U using Tapatalk

I came across a set of bed tie downs removed from a 1008/1028 that I would like to integrate into my civvy K25. Anyone know where they would be placed/located in the bed? Sent from my SM-G970U using Tapatalk