Search results

Anyone know how to go about pulling vacuum for an hvac system? I’m looking to retrofit an H1 hvac into the Hmmwv but trying to figure out the best way to pull a vacuum. Any ideas? Sent from my iPhone using Tapatalk

Hello wondering if anyone knows if there is a Fuse-able link between the starter and alternator. I have power at starter and half way up the wire on the motor to the alternator but no power to the alternator. Wondering if there is a fuse able link in the wire loom before I cut it up to look for...

Hello I had my steering gear box off for a few days and replaced with a new one. I turned the wheel left and right 100 times but I still seem to have an air in line issue as steering is hard unless you hold the brake down for a while then steering gets easier. I searched all over and can’t seem...

Does anyone know what is needed to do a helmet top install? I’m thinking of switching from a soft top to a helmet top. Wondering any seals or mounts needed or modifications Sent from my iPhone using Tapatalk

Anyone have the plan b hard top? If so how do you like it? Any issues or complaints? Pictures would be helpful Looking to pick a hard top up soon. Sent from my iPhone using Tapatalk

Does anyone know what ac compressor mount is used for the following ac compressor on a 6.5? Or if anyone has a spare they are looking to part with? Sent from my iPhone using Tapatalk

Hello, Finally had the doghouse off again to see the date code on the block. Trying to figure out the code. If I’m correct I believe it’s a 6.5 November 4th 1999. Is someone able to confirm? Also is this a decent block? I’ve heard there are some blocks that were known to be bad during a certain...

Hello, Does anyone have the file or know where to obtain information on the epa exemption for the military that stays with the vehicle throughout the life of the vehicle even if sold? I know the import exemption but trying to find the above mentioned exemption. Thank you Sent from my...

Does anyone know the inner diameter of the rear coil springs? Sent from my iPhone using Tapatalk

Anyone do a spin on fuel filter conversion on the M998? Looking for ideas Sent from my iPhone using Tapatalk

Everyone, I am creating this thread in hopes of creating a master list of current bills regarding the registration of the HMMWV for on road use. Please submit any information regarding new bills, Missing bills, updates, links to sources and discussion threads. Please refer to individual threads...

Hello Anyone know best way to connect n type connector from a vsq antenna base to an am/fm connector? So far I can only find n type to bnc and then bnc to am/fm Anyone have any ideas that may be better? Here is the antenna base which I want to connect to am/fm cable Sent from my iPhone...

Hello, I am looking for the 6 inner brackets / braces if anyone has them for sale for the A2 airlift bumper. I have the outermost 2 supports already. Please PM me if you have a set you are looking to part with. Thank you

Hello was wondering if anyone knows if you can mount the following antennas on an as-3885 base. Not sure if you could make an adapter or buy one or perhaps pick up a new spring that would work. I plan on using them just for a normal radio so not concerned with the frequency issues. Any ideas...

Hello, I have done a lot of searching and have yet to find the answer. I am looking to keep the original look of the military antenna but use it on an AM/FM car radio. Does anyone know how to do this or what may work? I do not have any parts at this time or models in mind. Any help would be...

Hello, I just purchased a 93 M998 and have a couple of issues. Hope someone might be able to point me in the right direction. High beam indicator comes on with lights on no matter if its high beam or low beam the light is on on the dash. 2 nd issue is the right blinker. When I turn on the...

Hello, Has anyone tried to switch out the standard light controller for a set of rocker switches or toggle switches? I would like to eliminate the old style light switch and use a set of rocker switches if possible. Anyone have any idea how to wire something like this up? Also has anyone...

Hello I just replaced the steering wheel with an aftermarket steering wheel and would like to connect the horn wire. Does anyone know how to remove the horn wire from the steering column so that I can connect a solid wire to the new horn button? Or does anyone have any other ideas on how to...

Anyone have any ideas on making a new doghouse to include cup holders and possibly a radio in a m998? Sent from my iPhone using Tapatalk

Hello, i just removed over the doghouse for the first time and realized the top 2 pins are not holding. When I look behind them on the metal bracket all I see is a hole. Nothing for it to grab onto. Any idea what I may be missing?