Search results

Anyone have or know where to get the shock absorbers for the front mid and rears? I broke a mid and front. Looking for on both mk23, or amk25.

And make it strong enough to accidently stand on like the old 5 tons

Might be easier to take a fender to a aluminum or sheetmetal workshop and made up instead of whatever the hell the current ones are made of

Be careful on the year. I got an off-road letter for my 2007 AMK25 this month. Exact verbiage Unless compliant with State and Federal regulations, these vehicles are for off-road use only. Most likely due to 2007 Carb emissions standards. 27 July to 5 Nov 2021 for 3rd EUC

July 24th Submitted, Recieved on Nov 5th. 2021

You can add up to 2 inches by unscrewing the Z out of the the female to female coupler.

Did you also end up cutting off the bed frame? I dont believe I saw it in the pic.

The isolocks work well? Looks clean.

A little bit under 13" The exhaust is at 12'6" if I recall right, and its about 4" taller than that. Ill measure it tomorrow

Mounted my S280 shelter onto the truck. Wish it was 3 inches shorter so I could keep the tailgate and sides on.

Installed a brand new splicer ctis for the tire. Problem fixed.

Tried towing a m1061 a few months ago and the pintle height is a problem. Bought a m1073 and find its a pretty good fit, like the m1061 but with larger tires and the pintle mates up much better.

Encountered a problem I havent noticed till I engaged the 2 to 7 ton mode on the truck. Rears normally run 35psi unloaded and 55 psi when in 7 ton mode. Never really had a need until recently testing a trailer and having a 3 ton container put onto the bed. Engaged in 7 ton mode and the...

My new favorite tool is a slap sledge bead breaker. Breaks the bead without me having to ding my rims from not slinging sledge hammers all day.

Gents, I pulled up the motivation and took the feet off my heavy tow bar to make sure itd fit. The tow bar has 1.5" pins and the gap is 2". The gap I need is 1.5" rough abouts. Can I just throw in some washers or is there a similar connector I could use instead. Also, how bad would it be to...

Truck recently started having the parking light indicator stay on for 2-3 mins when releasing the parking break. Truck rolls and brakes aren't engaged and the air tanks are full. (110-130 PSI) Anyone have a similar problem? It happens during warm and cold temperatures. Oshkosh MK23 2003

Tire hammer, oring plus spares, small wrench and socket set for the beadlock, tire soap with spray bottle, torque multiplier, 33mm deep socket 1 inch, milwaukee 3/4 heavy impact, 33mm 3/4 deep socket. 3/4 and a 7/8 flare wrench with the 90 degree head to remove the ctis, a 4ft 1 inch socket...

Size up the breakers to your gen set. If youre wiring it 3 ph 220/380 50hz for 10kw gen then thats only 20A 3 ph breaker. 3 phase 110/208 60 hz would be 30 to 50 3 ph amp breakers depending on what you could find.

There is no 3 phase 220v. Each leg is 220v and 2 legs youd get 380v. It being a 4kw device with a 30 amp breaker suggests its actually only using 220v single phase. That is for non usa power. The info on the water purifier is doesnt make much sense. Id check the individual pumps, motors, and...

Eli, What and how did your winch die? I ordered the same one myself and some green paint.