Ridgerunner
New member
- 791
- 6
- 0
- Location
- Holland, Mi
The winch top plate on my Bobbed Deuce is pretty trashed. The previous owner used bolts for a shear pin, and by the looks of the top plate had run the chain/grabhook in, on more than a few occasions![Rolling Eyes :roll: :roll:](https://www.steelsoldiers.com/images/smilies/icon_rolleyes.gif)
Any ways, I'm going to make a new top plate for my truck, and wanted to know if there was anyone else that needed one also. That way I can cut a few out at the same time while I have material on the shear, and form them on the break press while the proper dies and back gage are set up to do mine.
![Rolling Eyes :roll: :roll:](https://www.steelsoldiers.com/images/smilies/icon_rolleyes.gif)
Any ways, I'm going to make a new top plate for my truck, and wanted to know if there was anyone else that needed one also. That way I can cut a few out at the same time while I have material on the shear, and form them on the break press while the proper dies and back gage are set up to do mine.
Attachments
-
77.4 KB Views: 124