Anyone good with Radio and Vic-3 cables

[mrfarb]

This will be a tough one. I have 2 radio inputs to my Vic-3 :

1 - GMRS radio input through an A3206683-4 which has 6 pin on one side and MCS radio port connector the other.

2 - Bluetooth box input with A3206019-3 which connects to the MCS radio port.

The issue, both radio port connectors are oriented the same direction (see 1 cable attached below), and you can’t install them. Pic below shows the MCS port with 1 connected. Is there a way to clock this or is there another cable oriented a different direction? Larger pic to show more of the setup.

 

[FKAM]

You can adjust the "clocking" by losening the knurled sleeve. New cables are usually pretty tight but they do move enough to rotate the cable. It doesn't adjust a lot but usually enough to move things out of the way.

 

[mrfarb]

Sad to report back it wasn’t successful, but I did manage to somehow make Radio A port on the MCS no longer functional. It’s fine, I just connected an RIT to the end cable and hooked the Bluetooth up to the RIT. If you know you know. I’ll never need Radio A anyway.

 

[IroncladGA]

If you are looking for audio connector cables for VIC-3 that are clocked in opposite directions, look for CX-13473 (the cable will be indexed to 9 o'clock) and CX-13489 (cable indexed to 3 o clock). I have both cables available in new, unopened packaging. PM me if you need one or both.

Sent from my Pixel 8a using Tapatalk