- 753
- 1,332
- 93
- Location
- Highland, Indiana
Just bought a luverne brush guard for my m1151. Does anyone have installed pics? I'm looking for how the mounts were attached. Thanks!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Anyone have pictures of a luverne brush guard on ECV?
- Thread starter Mattguy
- Start date
- 753
- 1,332
- 93
- Location
- Highland, Indiana
Can you get a picture of the mounting plate where it goes on truck.
- 753
- 1,332
- 93
- Location
- Highland, Indiana
None of my holes line up.
GuntherRommel
Well-known member
- 264
- 525
- 93
- Location
- Bend, Oregon
I think you can reverse those bottom brackets, mine went on a non turbo the reverse way yours is now but had to drill out the tow loop holes
- 753
- 1,332
- 93
- Location
- Highland, Indiana
I've reversed them both ways. Its a no go. What was your non turbo? M1123? Because they are the same front mounting plate.
- 6,930
- 9,584
- 113
- Location
- Papalote, TX
That is freaky close to the one I built Must have seen a picture and it stuck!
Attachments
GuntherRommel
Well-known member
- 264
- 525
- 93
- Location
- Bend, Oregon
Yes M1123 , more detailed install pics on the what have you done thread page 311
Attachments
Last edited:
- 753
- 1,332
- 93
- Location
- Highland, Indiana
Thank you!
- 753
- 1,332
- 93
- Location
- Highland, Indiana
Like the airlift bumper!
- 753
- 1,332
- 93
- Location
- Highland, Indiana
Did you have to widen the two bolt holes?
- 753
- 1,332
- 93
- Location
- Highland, Indiana
These holes need to made bigger correct?
GuntherRommel
Well-known member
- 264
- 525
- 93
- Location
- Bend, Oregon
Yes reamed a little with a step bit, it was a very tight fit
- 753
- 1,332
- 93
- Location
- Highland, Indiana
I just seen that 86humv had posted a while back about winch style bumper brackets being different that what was shipped with mine. He had some for sale and I've tried messaging him.
- 753
- 1,332
- 93
- Location
- Highland, Indiana
Found what I need. I've combed thru all TM's and can't find a part number for these. Back to the books.
