Two Stroke Madness
Member
- 195
- 3
- 18
- Location
- Adams NY
That's usually caused by the basketball sized turbochargers needing ten minutes to spool up.
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Bobbed m923a2 and axles
- Thread starter Ibexe666
- Start date
Ford Mechanic
Active member
- 1,805
- 6
- 38
- Location
- Edenton, NC
Maybe but I've seen under the hood and tool box of one of them. 2 stage propane and 1 shot of NOS. 6.0's don't last long stock or modified. Ha ha!
I've seen then modified and pushed to the point that it splits the block down the lifter valley!
I've seen then modified and pushed to the point that it splits the block down the lifter valley!
Two Stroke Madness
Member
- 195
- 3
- 18
- Location
- Adams NY
Did you see the footage of that Case tractor that blew the upper portion of the block through it's hood?
- 5,981
- 4,221
- 113
I
I sold an 8.3 liter block to a guy who said he was getting 1000 hp out of them and split a block at tje cam....
I sold an 8.3 liter block to a guy who said he was getting 1000 hp out of them and split a block at tje cam....
Ford Mechanic
Active member
- 1,805
- 6
- 38
- Location
- Edenton, NC
No I hadn't. I'll have to look for it!
Ford Mechanic
Active member
- 1,805
- 6
- 38
- Location
- Edenton, NC
Dang, that's a stout block too!
Two Stroke Madness
Member
- 195
- 3
- 18
- Location
- Adams NY
It's on Youtube. The Pistons blew the top of the block off and the tractor ran over it's own engine.
Ibexe666
Member
- 123
- 6
- 18
- Location
- Florence, South Carolina
Im hoping to keep the hood,cab and bed . The plan is to try to not make it look to much like a frankentruck lol
Ibexe666
Member
- 123
- 6
- 18
- Location
- Florence, South Carolina
What beach is that in your pfp
Ford Mechanic
Active member
- 1,805
- 6
- 38
- Location
- Edenton, NC
Hatteras island NC. Just outside of Frisco, off the Billy Mitchell airport off road access.
Two Stroke Madness
Member
- 195
- 3
- 18
- Location
- Adams NY
The 8.3 block may be stout, but the rest is not. I've learned the hard way that an 8.3 is not to be hot rodded. Used to think that they were the 5.9's bigger badder brother. I was very disappointed to find out otherwise.