- 10,498
- 6,631
- 113
- Location
- Camp Wood/LC, TX
Sure enough got a new unit in and look at the front ds! I see this again and again! I guess they forget to mention this in 91B school!!!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Check your Driveshaft phasing on FMTVs!!
- Thread starter NDT
- Start date
oboyjohn
Active member
- 340
- 121
- 43
- Location
- Quebec , Canada
Seen this many times up here in Canada. One group of guys working on a HLVW 10 ton couldn't figure out why the T/case was wobbling back and forth. I took a quick look and the main drive shaft to the first rear axle was out of phase by a few spline teeth.
- 290
- 451
- 63
- Location
- Kansas
Forgive my ignorance, as im not familiar with these trucks, but do they not have a keyed spline? On the driveshafts I've had apart (1 ton and down) there is usually a wide spline that fits a matching space in the other half.
- 4,317
- 3,208
- 113
- Location
- Fort Worth, Texas
Nah, it will help shake the dirt off and keep the truck clean. Just send it. 
oboyjohn
Active member
- 340
- 121
- 43
- Location
- Quebec , Canada
Hi Eric.
No, they do not have a keyed or master spline. Quite often I have seen them out by 90 degrees, but not too often by a few spline teeth. I learned early in my career to ALWAYS mark a drive shaft before taking it apart. If not, not only will it be out of phase but also out of balance, which will destroy a drive shaft in short order.
No, they do not have a keyed or master spline. Quite often I have seen them out by 90 degrees, but not too often by a few spline teeth. I learned early in my career to ALWAYS mark a drive shaft before taking it apart. If not, not only will it be out of phase but also out of balance, which will destroy a drive shaft in short order.
- 290
- 451
- 63
- Location
- Kansas
Ok. Seems odd that they aren't keyed. I've always marked my driveshafts, as well. Just because.