deuce gasser ignition distributor parts

[rizzo]

Where is the best place to purchase parts for the stock military distributor ?

 

[JasonS]

Normal things like points can be had from NAPA. What are you looking for?

 

[rizzo]

Normal things like points can be had from NAPA. What are you looking for?

Rotor cap condsor points ballast resistor

 

[rizzo]

There seems to be a large gap between the cap and rotor. It quit on me while running last fall. I'm going to readjust the points but want to check the other parts. I'm Leary about the gap between cap and rotor.

 

[rizzo]

which tm has the ignition info in it?

 

[rizzo]

Bump

 

[Stretch44875]

I picked up a NOS distributor at a swap meet and swapped the internals with the reo dist. The one I picked up was the wrong rotation, but parts swapped just fine.

Any of the typical MV dealers will have the parts. White owl, saturn surplus, memphis, eastern, or boyle.

 

[Recovry4x4]

Winers in Akron OH and Antelope Valley still have a lot of gasser parts.

 

[73m819]

There seems to be a large gap between the cap and rotor. It quit on me while running last fall. I'm going to readjust the points but want to check the other parts. I'm Leary about the gap between cap and rotor.[/QUOTE]

If the rotor to cap gap opened, a chance the bushing/thrust washer that keeps the shaft in place in the stem DIED, allowing the shaft to drop a bit, does not take much to open the air gap enough to loose spark or at least make things bad enough that spark is so weak it might as well be none.

 

[JasonS]

If you can find one, a civvy distributor with a pertronix is a major improvement.

 

[rizzo]

thank you all.

 

[73m819]

What did you find out as to the problem

 

[jmoylan69]

Antelope valley truck - out of business?

Winers in Akron OH and Antelope Valley still have a lot of gasser parts.

just called the number TODAY and its been disconnected, did they go out of business?

 

[searls84]

just called the number TODAY and its been disconnected, did they go out of business?

They're still around, I called them last week about some torque rod ends. Google Sam Winer, that's where I got the number.