Deuce questions

[eeyore357]

Thanks. I made a puller that should work as good or better than the original one. Hopefully the rain will hold off tomorrow so I can try to get the pesky thing off. I will post pics of the puller tomorrow, weather permitting.

 

[eeyore357]

Got the old steering wheel off and column rethreaded and new steering wheel on. Replaced a few reflectors. Got new wood on the bows and finally got my cargo cover on. I have been painting and just general clean-up. I ordered a set of new wheel cylinders and after closer inspection I believe it's the axle seals. I should have a new set of axle seals and boots, remote master cylinder, and shocks in today. I am going to go ahead and replace everything so I don't have to worry about it for a long time. While I'm doing the axle seals I am going to replace all of the axle, trans, and transfer vents and run a tube up to the dash.

 

[eeyore357]

Axle seals, axle vent mod, wheel cylinders, fluid change, and remote master cylinder job has started..

 

[thj327]

Have fun. The axle seals aren't bad to do. I used a transmission jack to out the drum assembly on/off. Think it will be done for the this weekend

 

[eeyore357]

The palet jack was a big help! My friend is letting me use his garage to work on it and he's closed on the weekends. I hope I have it done before the Brierfield show.

 

[eeyore357]

like this.. or like this.. I couldn't find a good pic on my phone. Thanks for the help.

 

[brianp454]

The first pic (left side) is correct; the rubber side of the seal engages with the bearing outer race.

like this.. View attachment 452203 or like this.. View attachment 452204 I couldn't find a good pic on my phone. Thanks for the help.

 

[eeyore357]

Thank you!!