Do we have an official Bobbed Deuce picture thread? If not, here it is! Post em!

[Slate]

I may put the spare 395/85/20 on the driver's. Just need to move the spare tire bracket back a little to accommodate. I think I've seen a few do this.

 

[tobyS]

Do you have the crank up cable type like the A3 has for the 365... Should work, I notice the rest of the stuff is about 16" lower than the frame on them. I think you need 14" for the tire. Be careful it won't hit the driveshaft, but that's further to the passenger side so shouldn't.

I'm mounting mine like the 5 ton, have a big set of angle iron go from side to side. I want to clean the angle up and make the stamping on the structural steel visible. It says in big letters BETHLEHEM STEEL, USA on the side of them....I like that. Got them from a bridge I bought that was 120 years old (70 tons) and they are going to clean up just fine.

 

[Slate]

Do you have the crank up cable type like the A3 has for the 365... Should work, I notice the rest of the stuff is about 16" lower than the frame on them. I think you need 14" for the tire. Be careful it won't hit the driveshaft, but that's further to the passenger side so shouldn't.

I'm mounting mine like the 5 ton, have a big set of angle iron go from side to side. I want to clean the angle up and make the stamping on the structural steel visible. It says in big letters BETHLEHEM STEEL, USA on the side of them....I like that. Got them from a bridge I bought that was 120 years old (70 tons) and they are going to clean up just fine.

I have a cable type on one of my truck I'm going to rob. And I am thinking of a hydraulic lift hoist for my Five ton. M54.

Sent from my moto z3 using Tapatalk