Drock
New member
- 1,020
- 12
- 0
- Location
- Eatonton GA
So after chasing down my high idle problem by replacing both the high idle solenoid and the temp sensor. I decided to go ahead and replace the glow plug inhibitor / temp sensor located on the drivers side head. After much research I found out that a new one would be an updated version requiring a new pigtail to be wired in Part. The problem is the original one on the truck has a (1) wire connection. And the new pigtail has (2) wires. What do I do? do I just run one wire to ground and the other to the green wire? Or do I just connect them all together?.. Here's pics of both.........![glow plug sensor.jpg glow plug sensor.jpg](https://www.steelsoldiers.com/data/attachments/414/414547-b239e2605e42d99e1e3897c578c4312e.jpg)
![glow plug sensor2.jpg glow plug sensor2.jpg](https://www.steelsoldiers.com/data/attachments/414/414624-c20605ba2532d11d8ee34b80e7225761.jpg)
![glow plug sensor.jpg glow plug sensor.jpg](https://www.steelsoldiers.com/data/attachments/414/414547-b239e2605e42d99e1e3897c578c4312e.jpg)
![glow plug sensor2.jpg glow plug sensor2.jpg](https://www.steelsoldiers.com/data/attachments/414/414624-c20605ba2532d11d8ee34b80e7225761.jpg)