WILLYSOVERLAND
Member
- 103
- 11
- 18
- Location
- SHENANDOAH PA
I have a 1998 c2500 that had 400k on it when it spun a bearing. i picked up a 6.5 in a can on gl. has anybody here started one in the can? what do i have to do?(power,fuel) It looked better in the pictures then in person.
does anybody know what kind of compression i should have per cyl with all the glow plugs removed?
My thoughts were to run a rubber fuel line from the lift pump for fuel (off the truck).
I have a good starter from another truck.
I can hold down the can with a forklift and chain.
If i send 24 volts dc to the pump will it open the solenoid valve?
What about the pmd on the side of the pump, do I need to do anything with that?
any thoughts, ideas, pokes, experience would be greatly appreciated
TANKS, WILLYS
does anybody know what kind of compression i should have per cyl with all the glow plugs removed?
My thoughts were to run a rubber fuel line from the lift pump for fuel (off the truck).
I have a good starter from another truck.
I can hold down the can with a forklift and chain.
If i send 24 volts dc to the pump will it open the solenoid valve?
What about the pmd on the side of the pump, do I need to do anything with that?
any thoughts, ideas, pokes, experience would be greatly appreciated
TANKS, WILLYS