• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Heater Blower Motor Resistor Repair and Replace

74M35A2

Well-known member
4,145
332
83
Location
Livonia, MI
You could just source the low speed side from 12V and eliminate the failure prone resistor. If you are going to reinstall a resistor, I would use one of a higher wattage rating than what was specified. These burn-outs seem to be more prevalent than expected. Be sure the confirm the amp draw of your blower motor to confirm system integrity regardless.
 

Wildchild467

Well-known member
Steel Soldiers Supporter
2,052
57
48
Location
Milford / Michigan
That is what I did. I just got power from my dedicated 12 volt system (separate batteries and alternator for my 12 volt system). I don't have to worry about draining one battery with that system. I still would rather have a 100 watt resistor instead of getting power from my 12 volt system, but it works and I don't have to worry about a resistor going bad.
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks