-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Helmet top install
- Thread starter TexF18
- Start date
- 2,975
- 4,356
- 113
- Location
- Olympia/WA
will bolt right on.
I don't think you have to remove the channel for the soft top at the front of the frame, but it's been a few years so don't remember exactly.
- 16,789
- 24,129
- 113
- Location
- Burgkunstadt, Germany
There is a TB to explain this job, I believe.
badgerd
Electronic Jedi
- 102
- 65
- 28
- Location
- Chesapeake VA
You’ll need to remove the soft top channel from the windshield and the C pillar.
Installation instructions, for the Amtech tops, is the whole way at the bottom of the page here:
www.mcclarincomposites.com
Sent from my iPhone using Tapatalk
Installation instructions, for the Amtech tops, is the whole way at the bottom of the page here:
Legacy 4 Door - McClarin Composites
Helmet Hardtop® : Standard Convert your canvas top to a one-time permanent solution. Our Standard Top is our most popular model in the Helmet Hardtops® series with thousands in use by the Armed Forces today. In this configuration, the cargo area is covered, similar to a sport utility truck. We...
www.mcclarincomposites.com
Sent from my iPhone using Tapatalk
Thank youYou’ll need to remove the soft top channel from the windshield and the C pillar.
Installation instructions, for the Amtech tops, is the whole way at the bottom of the page here:
Legacy 4 Door - McClarin Composites
Helmet Hardtop® : Standard Convert your canvas top to a one-time permanent solution. Our Standard Top is our most popular model in the Helmet Hardtops® series with thousands in use by the Armed Forces today. In this configuration, the cargo area is covered, similar to a sport utility truck. We...
Sent from my iPhone using Tapatalk
- 195
- 273
- 63
- Location
- Flagstaff, Az
I just installed one. It's relatively easy. Just make sure everything is aligned before you drill any mounting holes.
(More manuals are available on their website).
- 6,937
- 9,599
- 113
- Location
- Papalote, TX
Make sure the rear side and rear "lips" are tight against the rear of the body, you may have to put a ratchet strap across the back to pull the bottom of the helmet top together so it fits tight against the body before drilling the holes for the rear mounts.
- 16,789
- 24,129
- 113
- Location
- Burgkunstadt, Germany
Please upload this Instruction book in the TM upload thread. I will then put it in the correct forum. Its good you posted it here, but in a year, no one will be looking here, but in the correct forum they will find it.
- 7,719
- 19,767
- 113
- Location
- Charlotte NC
.
I pushed 3 books and 2 Latch books.
Temporarily located at:
Helmet Top installation instructions for HMMWV
. The original discovery for these instruction books was made by @Dieselmeister on the AmTech site. Latch instructions from Fairchild Fasteners also attached.
www.steelsoldiers.com
- 16,789
- 24,129
- 113
- Location
- Burgkunstadt, Germany
All taken care of.