HMMWV Enhanced Inspection in Pennsylvania

[rcb]

Greetings... Anyone have their HMMWV run through and pass the Enhanced Vehicle Safelty Inspection in PA. ?
I'm curious what exactly they expect for a " front bumper area to have a horizontal bar installed to cap off angle
iron that protrudes between tow hooks " ? I don't want to install a full blown front bumper, so not sure what others
have done to satisfy this requirement.
Thanks...
Bob

 

[Carrera911]

The front end of these trucks are identical to the H1 except for perhaps the brush guard. They couldn't fail a factory H1. If it doesn't pass you could temporarily rig something. Like when you build a house you put up the plywood over the railing on your steps that exceeds the 3 inch gap limit. Or putting the cats back on your hot rod to pass emissions. Same kinda deal


Sent from my iPhone using Tapatalk

 

[NormB]

I actually saw a HMMWV here in Maryland a year or so ago that had a piece of 2x10 bolted to the front end for a bumper.

Didn't see the rear, but I imagine it had the same or an airlift bumper.

Probably from PA, no need for those here.

Yet.