• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

M1078 A1 tachometer diagram

Xengineguy

Well-known member
Supporting Vendor
226
768
93
Location
USA Indiana
Did some more experimenting today, tapped in to the crank sensor wiring . Did get a frequency reading, however the tach didn’t like it. Went back to the ac on the alternator. Works as long as the dash light are on. Will check out the ecu pins when I get more time.
Might be the best way.
 

coachgeo

Well-known member
5,147
3,463
113
Location
North of Cincy OH
Did some more experimenting today, tapped in to the crank sensor wiring . Did get a frequency reading, however the tach didn’t like it. Went back to the ac on the alternator. Works as long as the dash light are on. Will check out the ecu pins when I get more time.
Might be the best way.
maybe a capacitor(?) smooth out the signal?
 

GeneralDisorder

Well-known member
Steel Soldiers Supporter
2,038
5,224
113
Location
Portland, OR
maybe a capacitor(?) smooth out the signal?
A capacitor would tend to delete the signal by smoothing the AC into closer to a DC signal. Fundamentally the AC signal from the alternator VR is not designed to be a tach signal and the fact that it sort-of works is basically a coincidence - it's designed to send alternator RPM To the LBCD and to be sent/received by Niehoff equipment to matching Niehoff equipment - not a tach gauge.

As much of a pain as it will be, the ECM produces a tach signal for just this purpose and it's output will be perfect and uniform. It requires only to pin a few ECM pins and run a few wires and you have the actual correct data.
 

Ronmar

Well-known member
3,847
7,478
113
Location
Port angeles wa
What General said, wouldn't really effect freq, just suppress/average the signal amp;itude(turn AC into DC). Way back when, it was common to pull the tachometer signal from the alternator, but those signal points were designed for that. As mentioned, Neihoff intended this output for a specific purpose, so i think it is just luck that it worked at all:)

i am not sure what bell housing was used to interface the 3126 to the Allison, i wonder if it has the port for a tach sensor counting ring gear teeth like on the A0/3116 trucks?
 
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks