M1114 and Forging Exhaust

[MedicKam]

So I am installing the forging parts and the exhaust support bracket is next up. Looking under the wheel well I see there is the large lines running to the condenser. It seems that these fall inline with where the bracket should go.

Has anyone tacked this yet? I was thinking of just modifying the bracket so the hose lines can run through it. Any ideas would be great!

 

[Coug]

So I am installing the forging parts and the exhaust support bracket is next up. Looking under the wheel well I see there is the large lines running to the condenser. It seems that these fall inline with where the bracket should go.

Has anyone tacked this yet? I was thinking of just modifying the bracket so the hose lines can run through it. Any ideas would be great!

The early fording kit uses a different bracket than the later units with fender mount condensers. Not sure the specifics though

 

[MedicKam]

Coug,
Thanks! I’ll try looking that up.

 

[Retiredwarhorses]

The turbo trucks don’t need the old style bracket in the fender, there is a reinforcement plate installed on the inner fender…still required to have the rubber isolators, but that’s it.

 

[MedicKam]

The turbo trucks don’t need the old style bracket in the fender, there is a reinforcement plate installed on the inner fender…still required to have the rubber isolators, but that’s it.

Oh that good to know. I’ll look for that support bracket.