adv789
New member
- 49
- 0
- 0
- Location
- Post Falls, Idaho
hello again guys, i dont really know what my problem is so im asking you guys. here is what i did yesturday. i was tinkering around with my flame heater when i broke it off, so i took it out and left the other half threaded into the intake manifold to plug the hole until i could get a replacement for it. now i dont know if this has any coralation with the not starting problem, but now my truck turns over but wont start where as it used to turn right over and start up almost immediatly when it was warm. in order to get it to start now i have to give it a shot of either and turn her over then it reluctantly starts, after that though it runs fine. it just wont start byherself. it has the LDS 465-1A in it if that helps at all. i hope some of you guys has an idea, cause im lost.
i look forward to hearing.
Ryan
i look forward to hearing.
Ryan