Windowlicker
New member
- 12
- 3
- 3
- Location
- Connecticut
I set unit with hand held meter under load set to single phase 120/240 and getting power on L1 and L3
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Mep 802a keeps dropping out ac power at lugs only
- Thread starter Windowlicker
- Start date
- 3,827
- 5,934
- 113
- Location
- MA
S6 isn't your primary issue, if you have current on L2. Start there
Windowlicker
New member
- 12
- 3
- 3
- Location
- Connecticut
Nothing on L2 have to leave s6 on it or i get the short circut light
- 2,145
- 3,526
- 113
- Location
- Pepperell, Massachusetts
What happens when you set S6 to the 3 o'clock position and then start the set.
Does it still trip OL or SC?
Does it still trip OL or SC?
- 16,755
- 24,065
- 113
- Location
- Burgkunstadt, Germany
This is an interesting question, and the answer even more so.
Windowlicker
New member
- 12
- 3
- 3
- Location
- Connecticut
If i leave it in 3 oclock, Gauge's work. flip switch to closed loads, will come on if there is a change on load; i.e. add or remove unit trips on short circut or if i turn s6 it will trip on short circut. if i leave s6 in 9 oclock, unit will run normal loads on and off with no short circut
Last edited: