MEP-805B Magnetic Speed Pickup (MSP) Missing.

[dpTrail]

I bought MEP-805B on GovPlanet and after spending lot of time trying to start up discovered the MPS is missing. I found an MSP on Green Mountain for MEP-805B which showed the MPN to be a GAC MSP6728. When I found EBAY and went to order it says the thread is 5/8-18 but when I checked the hole is much bigger. Tried to measure and looks like maybe 3/4-16. Is there sopposed to be some kind of adapter on flywheel housing to use 5/8-18 MSP?

 

[Guyfang]

No. There is no adapter. Perhaps you should download the TM's for the MEP-805B.

All the TM's you need to work on the MEP-805B Generator set.

Here are the TM's you need to work on the MEP-805B generator set. Be advised, there are OTHER uploaded files that pertain to the MEP-805B in the TM forum. So LOOK for them.

www.steelsoldiers.com

MSP675C is the Part Number I see in the parts manual.

 

[dpTrail]

No. There is no adapter. Perhaps you should download the TM's for the MEP-805B.

All the TM's you need to work on the MEP-805B Generator set.

Here are the TM's you need to work on the MEP-805B generator set. Be advised, there are OTHER uploaded files that pertain to the MEP-805B in the TM forum. So LOOK for them.

www.steelsoldiers.com

MSP675C is the Part Number I see in the parts manual.

Thanks for the information on TM's link. Looking at MSP675C it appears to also be 5/8-18 thread. I am going to look at getting a thread insert to reduce the 3/4-16 to 5/8-18 to make it work hopefully.

 

[2Pbfeet]

If it were me, I would try a 5/8-18 bolt before going too much farther. I can't count the number of times I was sure that I had eyeballed the size of a bolt, only to be off.

Is an MSP675C a compact version of an MSP675?

All the best,

2Pbfeet

 

[dpTrail]

5/8-18 bolt fell right through. I used a vernier caliper to measure and fits drill size for 3/4-16.