MEP003A battery cables

[Vic_949]

I could be mistaken, but that looks like an 8xx slave port. If memory serves, the 003a is a round 2pin(side by side pins) instead of the round single pin.

Ok thank you for helping me that’s all the information I needed.

 

[Mullaney]

I could be mistaken, but that looks like an 8xx slave port. If memory serves, the 003a is a round 2pin(side by side pins) instead of the round single pin.

.
Thanks @justinn .

I made a minor edit to my original post.

 

[Ray70]

And normally it is hooked to the +side of the solenoid. The schematic is a bit misleading.

Correst Guy, P50A2 should be connecting from the +post on the starter solenoid to the +Pin of the slave port.
The schematic shows it connecting to P50A10, but in reality, both wires should be on the positive solenoid post.

 

[Light in the Dark]

I could be mistaken, but that looks like an 8xx slave port. If memory serves, the 003a is a round 2pin(side by side pins) instead of the round single pin.

I've seen both styles on 00X machines, with the 2 pin being the original design.

 

[Guyfang]

Correct. There are a few with the new NATO plug. We installed about 40-50 one summer, when we had nothing better to do, and there was about a million new plugs standing in a corner, new in boxes. But they are rare on the older sets.