Dgoff
New member
- 4
- 0
- 0
- Location
- Maple Valley/Wa
Hello, I bought a running 005a and shows voltage on all 3 legs at the meter but no voltage at the lugs. I don't see a breaker anywhere. It is a trailer mounted unit. There is a breaker box on the fender where you would plug in the power cord. No cord plugged just went straight to the lugs. I'm baffled! Can anyone give me some idea what it could be? I forgot about the 120 volt service plug works fine. If that helps! OK there is power from the 3 leads off of the generator head. Those 3 wires go into what could be a breaker with no switch. It is a little black box between the head and the lugs. There is a wire socket plugged into it. Not familiar with electronics so I'm at a disadvantage here. HELP!
The generator will not start from the start switch. I set the start switch up and release back to the run position. Then battle short on, then jump the solenoid at the starter. runs great! Go back to the start and excite the set. I have replaced the solenoid on the starter. Still doesn't work right. Not sure if this has anything to do with it. I was told there is a starter solenoid inside the box where a BUNCH of wires go into. Looks like it will be difficult to open and check. I was told it was similar to a ford solenoid.
Any Ideas?
Thanks
The generator will not start from the start switch. I set the start switch up and release back to the run position. Then battle short on, then jump the solenoid at the starter. runs great! Go back to the start and excite the set. I have replaced the solenoid on the starter. Still doesn't work right. Not sure if this has anything to do with it. I was told there is a starter solenoid inside the box where a BUNCH of wires go into. Looks like it will be difficult to open and check. I was told it was similar to a ford solenoid.
Any Ideas?
Thanks