KnuckleDuster
Member
- 27
- 42
- 13
- Location
- New jersey
You nailed it! 137T was hooked up to the lug (regulator) not excite. I swapped em over and it works perfect now! Can't thank you guys enough for all the help!
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Mep802a won't shut off!
- Thread starter KnuckleDuster
- Start date
Ray70
Well-known member
- 2,598
- 5,927
- 113
- Location
- West greenwich/RI
Ha! Fantastic. Glad we were able to figure that one out. Hopefully a new oil gage and you will be 100%
KnuckleDuster
Member
- 27
- 42
- 13
- Location
- New jersey
Any brands you recommend? Sender/ gauge combo?
Ray70
Well-known member
- 2,598
- 5,927
- 113
- Location
- West greenwich/RI
You can scroll through here and see what others have used.
The thing to watch out for is the gen is 24V but 80% of the gages out there are 12V.
Try to find a 24V 80 PSI gage, to make it easier.
Beede makes a lot of Marine gages which are affordable and look close to original, but you also have to buy a little $14 adapter board with a resistor in it to use with your 24V system.
I think your sender is ok. Think you had 240 ohms at 0 Psi. That sounds correct off the top of my head.
240 - 33 ohms if I recall correctly.
If you want to change it, I believe any 80 PSI sender with a 1/8" NPT thread and 240 -33 range will work.
I have used Sierra and Datcon before.
MEP-802A MEP-803A Filters and Parts
Howdy, MEP-802a and MEP-803a use all the same filters and such MEP-802A ONAN DN2M 2-cylinder engine (Lister-Petter LPW2) Liquid cooled diesel, aluminum housing MEP-803A ONAN DN4M 4-cylinder engine (Lister-Petter LPW4) Liquid cooled diesel, aluminum housing Oil Filter Spin-On (FILTER ELEMENT...
www.steelsoldiers.com
Try to find a 24V 80 PSI gage, to make it easier.
Beede makes a lot of Marine gages which are affordable and look close to original, but you also have to buy a little $14 adapter board with a resistor in it to use with your 24V system.
I think your sender is ok. Think you had 240 ohms at 0 Psi. That sounds correct off the top of my head.
240 - 33 ohms if I recall correctly.
If you want to change it, I believe any 80 PSI sender with a 1/8" NPT thread and 240 -33 range will work.
I have used Sierra and Datcon before.
- 16,790
- 24,136
- 113
- Location
- Burgkunstadt, Germany
Test before spending money.
I have used all 3 of the following Datcon gauges. All have worked perfectly for me with the senders that came on my 802a. I bought a second of each for when the Beede gauges fail on my NOS 802a. There are also 24v light kits available from the same vendor.
Fuel - 101584
OP - 101574
Temp - 101586
automotive gauges - Vehicle Controls
vehiclecontrols.com
Last edited: