mod five tonner rims

[stagehc]

I know this thread has been started but....


just for the record, can you slice out the center of 2.5 tonne rim and weld it into a 5 tonner super-single and then hack out the superflous middle section?



cheers from over here,

cole

 

[rdixiemiller]

Should be possible if you are a good welder.

 

[Trango]

Totally and 100% possible. They also make new 6 hole budd centres so you don't have to cannabalise a 2.5 tonne unit.

These guys should be able to sell you just the centres:

http://stazworks.com/rims.html

PS I've anglicised my American for easy reading.

Bob

 

[Desert Rat]

LOL!!!!

 

[40grit]

I had looked at water-jetting a center plate, with the 5 ton beadlock patterna and the 2.5 stud pattern, sandwich that between the 2 halves and bolt down, cut off the 5 ton pattern and you have some 2.5 ton rims, I had planned on 1/2 plate, widens the rim to 10.5" but no welding or chance of warpage..I'd try this with the older rims that had a bunch of bolts, not the newer ones that have 1/2 what the others did...somewhere spicer has pictures of the rims I was looking at...

 

[M1075]

I need another set of the 5 ton rims. Anybody found a good source for those? How much?

 

[stagehc]

Looks Like I wont need to go through all the drama. Here is a pic of a stock 2.5 tonne rim with a 395/85 XML stuffed on it. I was always taught you could use a narrower rim, but not a wider one.


Cheers from over here!

Cole