-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
My new Baby
- Thread starter Dino68
- Start date
ArmoredCTP
Member
- 22
- 48
- 13
- Location
- Waukesha/Wisconsin
Beautiful! Not easy to find the hard, four door pickup variant. Have fun with her!
Phoenix77
Well-known member
- 240
- 543
- 93
- Location
- Greenville, NC
Hard doors, soft top 
- 7,769
- 19,877
- 113
- Location
- Charlotte NC
.
Welcome to the outfit!
Looks like you have lots of wide open spaces to "go play truck"!
As a new member, be sure to go to the Technical Manual section and download the TM's.
Those are really handy when you need to know what wire does what and how to cover all the grease fittings, oil and filter information.
The list goes on and on. SEARCH in the TM's are your friend. Figuring out the terms takes a bit, but well worth your time!
Thank you I really appreciate it
- 573
- 1,284
- 93
- Location
- Chesterfield, Mi.
Hi Dino68. Welcome to the site. You will find a lot of information and helpful, friendly folks here. You have a nice looking truck there. I'm curious, did you have any issues getting it titled? Some states (like Michigan) make it almost impossible.
- 6,426
- 4,985
- 113
- Location
- Ft. Lauderdale, Florida
now you get to work on it
One hour drive
Two hours maintenance
One hour drive
Two hours maintenance
Hi Bill
Thank you titling in Arizone was a breeze took in thr SF document and got a tile in and out in 10 minutes
Lothar
Well-known member
- 324
- 661
- 93
- Location
- North Arkansas
Nice ride, welcome.
Phoenix77
Well-known member
- 240
- 543
- 93
- Location
- Greenville, NC
I have a 1986 AM General M998. I did initial fluid replacement (oil change, coolant flush, transmission fluid, changed fuel filter), installed two (2) new batteries, then the only other issue with the truck was what I surmised to be clogs in the fuel lines.
I had the tank pulled by a local shop and they cleaned it out and flushed the fuel lines. They said the mesh "trap" for foreign objects was COMPLETELY full of mess, and there was water etc in the tank. $400
After that, changing glow plugs a few months ago, and putting a few tanks of fuel through it with injector cleaning additive, it's running GREAT; significantly quicker than before.
Oh, and I replaced the rear diff, but I attribute that to being driven on base on high traction surfaces in HL it's entire life.
Do your due diligence initially and expect some frustration, but disregard the "1 hr drive, 2 hour maintenance" comment; these aren't boats.
I had the tank pulled by a local shop and they cleaned it out and flushed the fuel lines. They said the mesh "trap" for foreign objects was COMPLETELY full of mess, and there was water etc in the tank. $400
After that, changing glow plugs a few months ago, and putting a few tanks of fuel through it with injector cleaning additive, it's running GREAT; significantly quicker than before.
Oh, and I replaced the rear diff, but I attribute that to being driven on base on high traction surfaces in HL it's entire life.
Do your due diligence initially and expect some frustration, but disregard the "1 hr drive, 2 hour maintenance" comment; these aren't boats.
Mustangsud
Active member
- 154
- 216
- 43
- Location
- Aubrey, TX (North DFW Metro)
Agreed. We changed fluids and an overall lube service when we got ours, then have driven them hours and a bunch of miles without any maintenance issues.
- 2,069
- 3,025
- 113
- Location
- Florence, SC
Nice!
Caactus
Active member
- 83
- 202
- 33
- Location
- NW Phoenix, Arizona
Looks great. What part of AZ are you in? I’m in NW Phoenix and seeing a growing number of HMMWVs around.
Thank you I’m down south.